Kenwood VC-H1 Transmitting Images, Press MR to recall an image to be transmitted

Page 13

TRANSMITTING IMAGES

When an appropriate SSTV mode and a desired image is selected, the VC-H1 is ready to transmit images.

Note: AF Mute must be switched OFF {page 13} to transmit an image using Fast FM mode; the default is ON.

1Confirm that the VC-H1 has been correctly connected with the transceiver {page 5}.

On the transceiver:

2Turn ON the power to the transceiver.

3Select the same frequency as the other party.

On the VC-H1:

4Slide the PWR switch upward to turn the power ON.

•The TX/RX indicator lights green.

5Press [MR] to recall an image to be transmitted.

•The currently selected channel number appears at the top right of the monitor.

•Each press of [MR] increments the channel number.

•You may just look at the LCD monitor and focus the camera onto an object instead of recalling an image; you need not press [S] to capture an image.

6Press [TX] to transmit the image.

•You need not press the PTT switch.

•The TX/RX indicator lights red during transmission.

•A horizontal line appears and slowly moves downward to show the progress of transmission.

•To interrupt transmission, press [RX].

Note:

◆While transmitting, do not place the VC-H1 and the connection cable close to the transceiver antenna. The image on the monitor may be distorted or erased.

◆The VC-H1 cannot receive images while transmitting.

◆If no operation is performed for approximately 30 seconds after transmission, with Battery Saver ON {page 11}, the monitor is deactivated; the default is ON.

◆If you press [RX] after recalling an image, Battery Saver {page 11} deactivates the monitor.

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents
VC-H1 One or more of the following statements may be applicable Supplied Accessories FeaturesAccessory Part Number Quantity Thank YOUContents Conventions Followed in this Manual PrecautionsInstruction What to Do Press KEY1+KEY2Getting Acquainted Connector DescriptionsOrientation Preparation Installing Alkaline BatteriesInsert four AA LR6 alkaline batteries Attaching the Strap Connecting the AC AdapterConnection with a Handy Transceiver REMOVING/ Reinstalling the Camera Unit Quick USE Selecting a Sstv Mode Switching Power ON/OFFSlide the PWR switch upward to turn the power on To turn the power OFF, slide the PWR switch downwardPress S to activate both the camera and LCD monitor Capturing ImagesPress MR to store the captured image in a memory channel To confirm the stored images, press MRPress MR to recall an image to be transmitted Transmitting ImagesPress TX to transmit the image Tell the other party that you are ready to receive an image Receiving ImagesBattery Saver Memory ResetPress S+HOLD+ Power on Auxiliary FunctionsSuperimposing a Call Sign Press MR+HOLD+ Power on to switch the function on or OFFPress TX or RX to select the first digit Press Hold to complete the entryAuto Transmit Press TX+RX+ Power onAF Muting Display Contrast ChangeService MaintenanceService Note CleaningProblem Probable Cause Corrective Action TroubleshootingAppendix Connection Diagram with TS-570 or TS-870VC-H1 Data Port PIN Functions Pin No Pin Name FunctionComputer COM Port Pin Functions 9-Pin Port Computer ControlPin Name Function Inquiry of current Sstv mode Sstv mode switchCall sign superimposition Message superimpositionNtsc Specifications
Top Page Image Contents