Kenwood VC-H1 instruction manual Operating Basics, Switching Power ON/OFF, Selecting a Sstv Mode

Page 11

OPERATING BASICS

SWITCHING POWER ON/OFF

1 Slide the PWR switch upward to turn the power ON.

• The TX/RX indicator lights green.

2To turn the power OFF, slide the PWR switch downward.

SELECTING A SSTV MODE

To correctly transmit or receive images, you and the other party have to select the same SSTV mode. So first consult with your party about the mode to be used. You can select either Robot (color) 36 or Fast FM; the factory default is Robot (color) 36.

Note: The Fast FM mode is available only when using a TM-255, TM-455, TM-733, TM-V7, or TM-G707 transceiver; 9600 bps must be selected on the transceiver as the data transfer rate. For details, contact your authorized KENWOOD dealer, customer service, or service center. In Fast FM mode, the VC-H1 does not output audio from the speaker while receiving an image, and does not function as a speaker microphone.

Press [TX]+ POWER ON to switch the mode.

•The FAST FM indicator shows which mode is selected.

Lights red: Fast FM

Goes out: Robot (color) 36

The VC-H1 is also compatible with the following modes. See “RECEIVING IMAGES” {page 10} and “COMPUTER CONTROL” {page 17}.

•

Robot (color) 72

•

AVT 90

•

AVT 94

•

Scottie S1

•

Scottie S2

•

Martin M1

•

Martin M2

 

 

7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents
VC-H1 One or more of the following statements may be applicable Thank YOU FeaturesSupplied Accessories Accessory Part Number QuantityContents Press KEY1+KEY2 PrecautionsConventions Followed in this Manual Instruction What to DoOrientation Connector DescriptionsGetting Acquainted Insert four AA LR6 alkaline batteries Installing Alkaline BatteriesPreparation Attaching the Strap Connecting the AC AdapterConnection with a Handy Transceiver REMOVING/ Reinstalling the Camera UnitQuick USE To turn the power OFF, slide the PWR switch downward Switching Power ON/OFFSelecting a Sstv Mode Slide the PWR switch upward to turn the power onTo confirm the stored images, press MR Capturing ImagesPress S to activate both the camera and LCD monitor Press MR to store the captured image in a memory channelPress TX to transmit the image Transmitting ImagesPress MR to recall an image to be transmitted Tell the other party that you are ready to receive an image Receiving ImagesAuxiliary Functions Memory ResetBattery Saver Press S+HOLD+ Power onPress Hold to complete the entry Press MR+HOLD+ Power on to switch the function on or OFFSuperimposing a Call Sign Press TX or RX to select the first digitDisplay Contrast Change Press TX+RX+ Power onAuto Transmit AF MutingCleaning MaintenanceService Service NoteProblem Probable Cause Corrective Action TroubleshootingPin No Pin Name Function Connection Diagram with TS-570 or TS-870Appendix VC-H1 Data Port PIN FunctionsPin Name Function Computer ControlComputer COM Port Pin Functions 9-Pin Port Message superimposition Sstv mode switchInquiry of current Sstv mode Call sign superimpositionNtsc Specifications
Top Page Image Contents