Kenwood VC-H1 Precautions, Conventions Followed in this Manual, Instruction What to Do

Page 5

PRECAUTIONS

Please observe the following precautions to prevent fire, personal injury, or product damage:

•Never open this product. You will get an electric shock if you touch the circuit on which high voltage is applied.

•Do not install batteries in a hazardous environment where sparks could cause an explosion.

•Never discard old batteries in fire because extremely high temperatures can cause batteries to explode.

•Do not modify this product unless instructed by KENWOOD documentation.

•Do not apply excessive force to the monitor display.

•Do not expose this product to long periods of direct sunlight nor place it close to heating appliances.

•Do not place this product in excessively dusty areas, humid areas, wet areas, nor on unstable surfaces.

•If an abnormal odor or smoke is detected coming from this product, turn OFF the power immediately and remove the batteries from the product. When using AC power, also remove the AC adapter from an AC outlet. Contact your authorized KENWOOD dealer, customer service, or service station.

CONVENTIONS FOLLOWED IN THIS MANUAL

The writing conventions described below have been followed to simplify instructions and avoid unnecessary repetition.

Instruction

What to Do

 

 

Press [KEY].

Press and release KEY.

 

 

Press [KEY1]+[KEY2].

Press and hold KEY1, then

press KEY2.

 

 

 

Press

With VC-H1 power OFF,

press and hold KEY, then

[KEY]+ POWER ON.

slide the PWR switch upward.

 

 

 

 

With VC-H1 power OFF,

Press [KEY1]+[KEY2]+

press and hold KEY1 and

POWER ON.

KEY2, then slide the PWR

 

switch upward.

 

 

Note: Pressing the same key again immediately after pressing [KEY]+ POWER ON causes the setting to be changed back.

1

Page 4 Page 6
Image 5
Page 4 Page 6
Contents VC-H1 One or more of the following statements may be applicable Supplied Accessories FeaturesAccessory Part Number Quantity Thank YOUContents Conventions Followed in this Manual PrecautionsInstruction What to Do Press KEY1+KEY2Orientation Connector DescriptionsGetting Acquainted Insert four AA LR6 alkaline batteries Installing Alkaline BatteriesPreparation Attaching the Strap Connecting the AC AdapterConnection with a Handy Transceiver REMOVING/ Reinstalling the Camera UnitQuick USE Selecting a Sstv Mode Switching Power ON/OFFSlide the PWR switch upward to turn the power on To turn the power OFF, slide the PWR switch downwardPress S to activate both the camera and LCD monitor Capturing ImagesPress MR to store the captured image in a memory channel To confirm the stored images, press MRPress TX to transmit the image Transmitting ImagesPress MR to recall an image to be transmitted Tell the other party that you are ready to receive an image Receiving ImagesBattery Saver Memory ResetPress S+HOLD+ Power on Auxiliary FunctionsSuperimposing a Call Sign Press MR+HOLD+ Power on to switch the function on or OFFPress TX or RX to select the first digit Press Hold to complete the entryAuto Transmit Press TX+RX+ Power onAF Muting Display Contrast ChangeService MaintenanceService Note CleaningProblem Probable Cause Corrective Action TroubleshootingAppendix Connection Diagram with TS-570 or TS-870VC-H1 Data Port PIN Functions Pin No Pin Name FunctionPin Name Function Computer ControlComputer COM Port Pin Functions 9-Pin Port Inquiry of current Sstv mode Sstv mode switchCall sign superimposition Message superimpositionNtsc Specifications
Top Page Image Contents