Kenwood VC-H1 Preparation, Installing Alkaline Batteries, Insert four AA LR6 alkaline batteries

Page 7

PREPARATION

INSTALLING ALKALINE BATTERIES

WARNING!

◆DO NOT INSTALL THE BATTERIES IN A HAZARDOUS ENVIRONMENT WHERE SPARKS COULD CAUSE AN EXPLOSION.

◆NEVER DISCARD OLD BATTERIES IN FIRE BECAUSE EXTREMELY HIGH TEMPERATURES CAN CAUSE BATTERIES TO EXPLODE.

1To remove the battery cover, slide the cover outward while slightly pushing on the grooves on the cover.

Grooves

2Insert four AA (LR6) alkaline batteries.

•Be sure to match the battery polarities with those marked on the VC-H1.

3Align the three tabs on the battery cover, then slide the cover inward until the center tab clicks.

Center tab

Note:

◆It is strongly recommended to use high quality alkaline batteries rather than manganese batteries, to enjoy longer periods of battery life. Do not use commercially available NiCd batteries.

◆If you will not use the VC-H1 for a long period, remove the batteries from the VC-H1.

◆Do not use different kinds of batteries together.

◆When the battery voltage is low, replace all four old batteries with new ones.

The approximate lives of alkaline batteries depending on the operation status are shown below:

Camera ON

50 minutes

 

 

Monitor ON (memory recalled)

2 hours

 

 

Monitor OFF

6 hours

 

 

When the batteries become almost empty while the TX/RX indicator is green, the indicator starts blinking. Replace the batteries at that time. This function, however, does not operate while Fast FM mode is currently selected.

3

Page 6 Page 8
Image 7
Page 6 Page 8
Contents VC-H1 One or more of the following statements may be applicable Thank YOU FeaturesSupplied Accessories Accessory Part Number QuantityContents Press KEY1+KEY2 PrecautionsConventions Followed in this Manual Instruction What to DoGetting Acquainted Connector DescriptionsOrientation Preparation Installing Alkaline BatteriesInsert four AA LR6 alkaline batteries Attaching the Strap Connecting the AC AdapterConnection with a Handy Transceiver REMOVING/ Reinstalling the Camera UnitQuick USE To turn the power OFF, slide the PWR switch downward Switching Power ON/OFFSelecting a Sstv Mode Slide the PWR switch upward to turn the power onTo confirm the stored images, press MR Capturing ImagesPress S to activate both the camera and LCD monitor Press MR to store the captured image in a memory channelPress MR to recall an image to be transmitted Transmitting ImagesPress TX to transmit the image Tell the other party that you are ready to receive an image Receiving ImagesAuxiliary Functions Memory ResetBattery Saver Press S+HOLD+ Power onPress Hold to complete the entry Press MR+HOLD+ Power on to switch the function on or OFFSuperimposing a Call Sign Press TX or RX to select the first digitDisplay Contrast Change Press TX+RX+ Power onAuto Transmit AF MutingCleaning MaintenanceService Service NoteProblem Probable Cause Corrective Action TroubleshootingPin No Pin Name Function Connection Diagram with TS-570 or TS-870Appendix VC-H1 Data Port PIN FunctionsComputer COM Port Pin Functions 9-Pin Port Computer ControlPin Name Function Message superimposition Sstv mode switchInquiry of current Sstv mode Call sign superimpositionNtsc Specifications
Top Page Image Contents