Table 2. Numeric error codes (continued)

Symptom or error

FRU or action, in sequence

 

 

0193

Enter the supervisor password.

RF antenna has been removed

 

 

 

 

0194

Enter the supervisor password.

The computer has been carried through a security gate

 

 

 

 

 

0195

1.

Enter BIOS Setup Utility by entering supervisor

Security hardware tamper detected

 

password, and select “Password” >“ Security

 

 

Chip” >“Clear Security Chip” to clear this error.

 

2.

Security chip.

 

3.

System board.

 

 

 

0196

1.

Enter BIOS Setup Utility by entering supervisor

Security hardware removed

 

password, and select “Password” >“ Security

 

 

Chip” >“Clear Security Chip” to clear this error.

 

2.

Security chip.

 

3.

System board.

 

 

0197

The remote configuration for the security chip has

Invalid remote change requested.

failed. Confirm the operation and try again.

 

 

 

0199

1.

Run BIOS Setup Utility, and then save the current

System Security— Security password retry count

 

setting by pressing F10.

exceeded.

2.

System board.

 

 

 

01C8

1.

Remove either a Mini-PCI Card or a modem

Two or more modem devices are found. Remove all but

 

daughter card. Otherwise, press Esc to ignore

one of them. Press <Esc> to continue.

 

the warning message.

 

2.

System board.

 

 

 

01C9

1.

Remove either a Mini PCI Ethernet card or an

Two or more Ethernet devices are found. Remove all but

 

Ethernet daughter card. Otherwise, press Esc to

one of them. Press <Esc> to continue.

 

ignore the warning message.

 

2.

System board.

 

 

 

01C9

1.

Remove the Ethernet device that you installed; or

More than one Ethernet devices are found. Remove one

 

press Esc to ignore the warning message.

of them. Press <Esc> to continue.

2.

System board.

 

 

 

01CA

1.

Remove the wireless LAN device that you

More than one Wireless LAN devices are found. Remove

 

installed.

one of them.

2.

System board.

 

 

 

0200

1.

Reseat the hard disk drive.

Hard disk error—The hard disk is not working.

2.

Load Setup Defaults in BIOS Setup Utility.

 

3.

Hard disk drive.

 

4.

System board.

 

 

021x

Run interactive tests of the keyboard and the auxiliary

Keyboard error.

input device.

 

 

 

42ThinkPad X200 Tablet and X201 Tablet Hardware Maintenance Manual

Page 50
Image 50
Lenovo 3093AC6 Enter the supervisor password, Enter Bios Setup Utility by entering supervisor, Ignore the warning message