Lenovo 3093AC6 manual Numeric error codes

A numeric error is displayed for each error detected in POST or system operation. In the displays, n can be any number.

If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not described there, go to “Intermittent problems” on page 48.

Note:

For a device not supported by diagnostic codes in the ThinkPad Notebooks, see the manual for that device.

Numeric error codes

Table 2. Numeric error codes

Symptom or error	FRU or action, in sequence
0175	System board.
Bad CRC1, stop POST task—The EEPROM checksum is
not correct.
0176	1.	Run BIOS Setup Utility, and save the current
System Security—The system has been tampered with.		setting by pressing F10.
	2.	System board.
0177	System board.
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
0182	1.	Run BIOS Setup Utility. Press F9, and Enter to
Bad CRC2. Enter BIOS Setup and load Setup		load the default setting. Then save the current
defaults.—The checksum of the CRS2 setting in the		setting by pressing F10.
EEPROM is not correct.	2.	System board.
0185	1.	Run BIOS Setup Utility. Press F9, and Enter to
Bad startup sequence settings. Enter BIOS Setup and		load the default setting. Then save the current
load Setup defaults.		setting by pressing F10.
0187	System board.
EAIA data access error—The access to EEPROM is failed.
0188	System board.
Invalid RFID Serialization Information Area.
0189	System board.
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190	1.	Charge the battery pack.
Critical low-battery error	2.	Battery pack.
0191	1.	Run BIOS Setup Utility, and then save current
System Security—Invalid Remote Change requested.		setting by pressing F10.
	2.	System board.
0192	System board.
System Security— Embedded Security hardware tamper
detected.

Chapter 4. Related service information 41