| i n t e l l i g e n t | w i r e l e s s | p l a t f o r m | |
|
|
| ||
| Chooses which key in the key table is used for authentication: 1 – 4 | |||
Valid Key | This value must be match between the root device and the Client. |
| ||
|
|
|
|
|
| Display / Set WEP keys |
|
|
|
Key Table | A maximum of four keys can be set. |
|
|
|
|
|
|
|
|
Follow the steps below to configure the Data Encryption parameters:
1.Click the ‘Security’ link from the ‘Radio Main’ page of the desired radio.
2.Click the ‘Enable’ button on the WEP.
3.Choose the Authentication as ‘Open System’ or ‘Shared Key’ by clicking on the radio button.
4.Choose a WEP Key Size (64 Bits or 128 Bits) from the dropdown menu. WEP key length is 10 characters for 64 Bits and 26 characters for 128 Bits.
5.Choose a Valid Key from the dropdown menu.
6.Enter the WEP key in the Key Table entries.
7.Click the ’Apply Changes’ button to change the settings.
Note: The system will validate the key entries and provide error or warning notifications. The user must enter the key indicated by the Valid Key selection.
Figure 2-53 WEP Only Configuration
airHaul2 Nexus PRO™ User Guide | Page 68 of 113 |
|