Uniden EXA 8955 manual Preparing the battery pack, Status LED

Page 13

Use only Uniden Battery BT-905.

Preparing the battery pack

Charge the battery pack for more than 12-15 hours before you start using your phone.

1	Remove the battery cover.
2	Connect the battery pack
	connector with the correct
	polarity (black and red wires),
	then insert the battery pack
Black	into the battery compartment.
Red
3	Slide the battery cover forward
	until it snaps into place.

4 Place the handset on the base. Make sure that the “status” LED of the base unit lights, and charging begins. Charge the battery for at least 12-15 hours. You can place either side up for charging the battery.

status LED

10

Image 13

Contents Page Introduction FeaturesControls and functions 50 51 52 Contents Base unit Read this firstHandset Checking the package contents Choose the best location Setting up the baseConnect the base unit If you want to install the base unit on the wall, seeIf your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing systemStandard wall plate mounting Mounting the base unit on a wallIs firmly seated Direct wall plate mounting Status LED Preparing the battery packWhen the battery charge becomes low Battery use time per chargeCleaning the battery contacts Do not use any liquids or solventsFrom the handset Making a callFrom the base Other OperationsHandset on the base Receiving a callHandset off the base Handset ringer tone Adjusting the ringer and ear speaker volumeLast phone number entered can be quickly redialed Redialing a callWhen speaking on the base When speaking on the handsetWhen the phone is ringing MuteFrom the handeset Storing phone numbersMaking calls with memory dialing From the handset Erasing a stored phone number Way conferencing Intercom from the handset to base To transfer from the handset to the base Transferring a callTo transfer from the base to the handset Integrated answering device IntegratedSetting the clock » Preset Message Setting your greeting» Recording your personal outgoing message Greeting » Choosing between two outgoing messagesSelecting the message record time » Announce only featureSelecting a PIN code Setting ring time switch Playing your message Using your answering systemSkipping a message Repeating a messageVoice memo Deleting a message» Deleting individual message » Deleting all messagesRecording a conversation Command Function Remote access away from homeRemote room monitor Changing the digital security code Additional InformationHeadset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion General SpecificationsBase unit HandsetK, L IndexW, X, Y, Z Page