Uniden EXA 8955 manual Remote access away from home, Command Function

Page 35

You must enter a command within 15 seconds of entering command waiting mode or the answering system automatically hangs up and returns to standby.

The system will only playback messages for four minutes and then it returns to command waiting mode. To continue playing your message, press # then 2 again within 15 seconds

Remote access away from home

You can operate your answering system from a remote location using any touch-tone telephone. Use this function to check for recorded messages, to play or delete messages, even to record a new outgoing message, and to monitor sounds in the room.

1 Call your telephone number.

2 During the answering machine is activated, press # and your PIN code.

3 The answering system announces the time and day stamp and the number of messages stored in memory. Then the message playback automatically begins.

4 You may continue to listen to your massage, or you may select a command from the following chart.

Command Function

# then 1

Repeat

#then 2 Playing your messages

#then 3 Skipping a message

#then 4 Deleting a message

#then 5 Stop message playback

#then 6 Answering system on

#then 7 Voice memo record/stop

#then 8 Outgoing message record/stop

#then 9 Answer system off

# then*

Room monitor

5 After all of your messages have played, or the playback time exceeds 4 minutes, you will hear that the intermittent beeps indicating that the system is in the command waiting mode. You may enter another command at this time from the chart above.

6 When you are finished, hang up to exit the system. The answering system automatically returns to standby.

32

Image 35

Contents Page Introduction FeaturesControls and functions 50 51 52 Contents Handset Read this firstBase unit Checking the package contents Choose the best location Setting up the baseConnect the base unit If you want to install the base unit on the wall, seeIf you arent sure of your dialing system Choose the dialing modeIf your dialing system is Set the switch to Tone PulseIs firmly seated Mounting the base unit on a wallStandard wall plate mounting Direct wall plate mounting Status LED Preparing the battery packDo not use any liquids or solvents Battery use time per chargeWhen the battery charge becomes low Cleaning the battery contactsOther Operations Making a callFrom the handset From the baseHandset off the base Receiving a callHandset on the base Handset ringer tone Adjusting the ringer and ear speaker volumeLast phone number entered can be quickly redialed Redialing a callMute When speaking on the handsetWhen speaking on the base When the phone is ringingFrom the handeset Storing phone numbersMaking calls with memory dialing From the handset Erasing a stored phone number Way conferencing Intercom from the handset to base To transfer from the base to the handset Transferring a callTo transfer from the handset to the base Integrated answering device IntegratedSetting the clock » Choosing between two outgoing messages Setting your greeting» Preset Message » Recording your personal outgoing message GreetingSelecting a PIN code » Announce only featureSelecting the message record time Setting ring time switch Playing your message Using your answering systemSkipping a message Repeating a message» Deleting all messages Deleting a messageVoice memo » Deleting individual messageRecording a conversation Command Function Remote access away from homeRemote room monitor Changing the digital security code Additional InformationTo attach the beltclip To remove the beltclip Installing the beltclipHeadset installation Battery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion Handset SpecificationsGeneral Base unitW, X, Y, Z IndexK, L Page