Uniden EXAI 7980 owner manual Connect the base unit

Page 7

Step 2 (continued)

Connect the base unit

If you want to install the base unit on the wall, see page 45.

Route the cord.

2

To AC outlet

To DC IN 9V

1

AC adapter (supplied)

To telephone outlet

Telephone line cord (supplied)

To TEL LINE

3

1 Connect the telephone line cord to the

TEL LINE jack and to a telephone outlet.

Note Until the handset battery is fully charged, you can only answer incoming calls at the base unit.

2 Connect the AC adapter to the

DC IN 9V jack and to a standard 120VAC wall outlet.

3 Set the base unit on a desk or tabletop and place the handset on the base unit.

Then raise the antenna to a vertical position.

Note

Place the power cord so it does not create a trip hazard, or where it could become chafed and create a fire or electrical hazard.

7

Image 7

Contents Exai Introduction FeaturesTable of contents 11 to Read this first6 to 9 to10Step Checking the package contentsChoose the best location Setting up the base unitConnect the base unit Tips Choose the dialing modePreparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Setting Caller ID options Entering your area code On-hook dialing Making callsOff-hook dialing On-hook redialing RedialingOff-hook redialing Receiving calls Auto Talk when ringingAny key when ringing Any key when pagingHandset ringer tone Handset ear speaker volumeBase speaker volume Base ringer switchReceiving a call from the base Storing phone numbers and names Memory storingDn »key to scroll through the characters Making calls with memory dialing Memory dialingOn-hook dialing Display a Programmed Number Off-hook dialingEditing a stored name and/or phone number Memory editingUse the #/ 1 and */tone/0 Erasing a stored name and/or phone number Memory erasingCaller ID Caller ID serviceHere are some typical displays When the telephone ringsViewing the Caller ID Message list Long Distance call settings and cancellationDeleting a Caller ID message Deleting information from the Caller ID listDeleting all Caller ID name/numbers Calling a party from the Caller ID list Using the Caller ID listLong Distance calls Storing Caller ID messages in Memory Using Caller ID with call waiting service Setting the clock Using the answering machineChanging the greeting Recording the greetingTurning the answering machine on and off Setting the number of ringsSetting maximum recording time for incoming messages Setting the toll saver switchPlaying recorded messages Screening incoming calls Deleting recorded messagesLeaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor Way conversation When speaking on the handsetWhen speaking on the base Additional informationChanging the digital security code Standard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure Symptom Suggestion TroubleshootingAdditional information Handset SpecificationsGeneral Base unitW, X, Y, Z IndexG, H K, LPage Uniden America Corporation