Using the answering machine (continued)
Remote access
You can operate your answering system from a remote location using any
1
2 During the greeting playback, press # followed by your PIN code. Refer to page 42 for instructions on how to select a PIN code.
3 The answering system announces the time and day stamp followed by the number of messages stored in memory. Message playback automatically begins.
4 You may continue to listen to your messages, or you may select a command from the following chart:
Function | Press |
|
|
Repeat a Message | # then 1 |
|
|
Playing your Messages | # then 2 |
|
|
Skipping a Message | # then 3 |
|
|
Deleting a Message | # then 4 |
|
|
Stop Message Playback | # then 5 |
|
|
Answering System On | # then 6 |
|
|
Memo Record/Stop | # then 7 |
|
|
Greeting Record/Stop | # then 8 |
|
|
Answering System Off | # then 9 |
|
|
Remote Room Monitor | # then* |
|
5 After all of your messages have played, you will hear intermittent beeps indicating that the system is in the command waiting mode. You may enter another command at this time from the chart above.
6 When you are finished, hang up to exit the system. The answering system auto- matically returns to standby.
Notes
•You must enter a command within 15 seconds of entering command waiting mode or the answering system automatically hangs up and returns to standby.
•The system will only play back messages for four minutes and then it returns to
command waiting mode. To continue playing your messages, press # then 2 again | 43 |
within 15 seconds. |