Uniden XC3545 important safety instructions Automatic Digital Code Security

Page 29

Automatic Digital Code Security

Many cordless telephones operate similarly and on the same frequency. Without digital code security, another Handset could make calls using your Base Unit and telephone line. To avoid unauthorized calls on your phone, a Digital Code feature was added to the:+!#"#. This Digital Code is shared only between the Handset and Base Unit. The Code is set automatically when you first use the phone.

To reset the Digital Code, be sure the Handset is on the Base, then:

1.Press Ion the Base Unit.

Note: The phone begins ringing when Iis pressed.

2.Remove the Handset from the Base Unit, and then set it down again. (The ringing will stop.)

29

Image 29

Contents Table of Contents Important Safety Instructions Page Introduction FeaturesIncluded with the XC3545 Range Telephone Line ProblemsImportant Electrical Considerations More Than One Cordless Telephone Radio InterferenceTelephone Line Outlets InstallationSelecting a Location Applying Power to the Base Unit Connecting the Telephone CordsDesk or Tabletop Installation Adapter Safety FeaturePage Page Standard Wall Plate Mounting Wall InstallationPlacement of the Handset Page Page Direct Wall Mounting Page Page Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Extending the Antenna Setting up your PhoneInstalling the Handset Battery Pack BLK RED Cleaning the Battery Contacts Initial Battery Charging Charging the Battery PackContinuous Battery Charging During a Call Standby Mode Low Battery IndicatorHandset Volume Controls Setting the Tone/Pulse SwitchAdjusting Ringer/Volume Controls Base Volume Controls Automatic Digital Code Security ExtendAPhone ExtendAPhone Making and Receiving Calls Using your XC3545TALK/BA LOW LED will Changing Channels, Hold, Mute, and FlashPaging the Base Unit Using Page/IntercomWay Paging Paging the Handset Transferring a CallINT’COM LED Transferring a Call from the HandsetTransferring a Call from the Base To turn the monitor off Room Monitor FeatureHandset Operation Programming your PhoneStoring a Number in Memory Tone indicates that the number is stored USE LED blinks Base OperationPress Magain Enter the memory location Storing a Tone/Pulse Number With a Pulse Dial System 3300 Enter the number to be Tone indicates that the number is stored Storing One-Touch Dialing Numbers Channel Press M Tone indicates that the number is stored Chain Dialing Dialing a Stored NumberErasing a Stored Number Problem Suggestion TroubleshootingHandset XC3545 Precautions Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty Covered under one or more of the following U.S. patents