Uniden XC3545 Installation, Selecting a Location, Telephone Line Outlets

Page 8

Installation

Selecting a Location

Before choosing a location for your new phone, there are some important guidelines you should consider:

∙The location should be close to both a phone jack and continuous power outlet. (A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.)

∙Keep the Base Unit and Handset away from sources of electrical noise such as motors or fluorescent lighting.

∙Be sure there is sufficient space to fully extend the Base Unit antenna.

∙The Base Unit can be placed on a desk or tabletop or mounted on a standard AT&T or GTE wall plate.

∙If you decide to mount your phone on the wall, make sure to change the handset retainer so that the tab which holds the Handset faces up. (See page 19 for more information.)

∙You should charge your new phone for 15-20 hours before completing the installation or using the Handset.

Telephone Line Outlets

There are two types of phone outlets:

Modular Jack

Most phone equipment available now uses modular jacks. Phone cords are fitted with a molded plastic connector which plugs into this type of jack. If you do not have modular phone jacks, contact your local telephone company for information about their installation.

Hard-wired Jack

Some equipment is wired directly to a phone jack, and these types of installations require a modular jack converter. This type of installation is not difficult; however, you should contact your Uniden telephone dealer or a telephone supply store for advise about the proper adapter or converter for your particular situation.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Table of Contents Important Safety Instructions Page Features IntroductionIncluded with the XC3545 Range Telephone Line ProblemsImportant Electrical Considerations Radio Interference More Than One Cordless TelephoneTelephone Line Outlets InstallationSelecting a Location Connecting the Telephone Cords Applying Power to the Base UnitAdapter Safety Feature Desk or Tabletop InstallationPage Page Standard Wall Plate Mounting Wall InstallationPlacement of the Handset Page Page Direct Wall Mounting Page Page Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Extending the Antenna Setting up your PhoneInstalling the Handset Battery Pack BLK RED Cleaning the Battery Contacts Charging the Battery Pack Initial Battery ChargingContinuous Battery Charging Low Battery Indicator During a Call Standby ModeHandset Volume Controls Setting the Tone/Pulse SwitchAdjusting Ringer/Volume Controls Base Volume Controls Automatic Digital Code Security ExtendAPhone ExtendAPhone Using your XC3545 Making and Receiving CallsChanging Channels, Hold, Mute, and Flash TALK/BA LOW LED willPaging the Base Unit Using Page/IntercomWay Paging Transferring a Call Paging the HandsetTransferring a Call from the Handset INT’COM LEDTransferring a Call from the Base Room Monitor Feature To turn the monitor offHandset Operation Programming your PhoneStoring a Number in Memory Tone indicates that the number is stored Base Operation USE LED blinksPress Magain Enter the memory location Storing a Tone/Pulse Number With a Pulse Dial System 3300 Enter the number to be Tone indicates that the number is stored Storing One-Touch Dialing Numbers Channel Press M Tone indicates that the number is stored Dialing a Stored Number Chain DialingErasing a Stored Number Troubleshooting Problem SuggestionHandset XC3545 Precautions Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty Covered under one or more of the following U.S. patents
Top Page Image Contents