Uniden XC3545 important safety instructions Using Page/Intercom, Way Paging, Paging the Base Unit

Page 34

Using Page/Intercom

The 2-Way Page/Intercom feature allows you to communicate between the Base Unit and Handset. To use this feature remember the following:

∙The RING ON/BATT SAVE switch on the Handset must be in the RING ON position.

∙The BASE UNIT RINGER switch must be set to either LO or HI.

Note: If you are on a call while using the Handset and you page the Base Unit, the Base Unit will ring even when the Base ringer switch is set to the OFF position.

2-Way Paging

Paging the Base Unit

1.Press Jon Handset.

Note: f there is Jno answer, press

again to cancel.

2.Press K

orIon Base Unit to answer page.

The IN USE LED blinks and the

INT’COM LED lights.

To end the conversation:

3.PressTon the Handset orI on the Base.

3

1

2

34

Image 34

Contents Table of Contents Important Safety Instructions Page Features IntroductionIncluded with the XC3545 Important Electrical Considerations Telephone Line ProblemsRange Radio Interference More Than One Cordless TelephoneSelecting a Location InstallationTelephone Line Outlets Connecting the Telephone Cords Applying Power to the Base UnitAdapter Safety Feature Desk or Tabletop InstallationPage Page Placement of the Handset Wall InstallationStandard Wall Plate Mounting Page Page Direct Wall Mounting Page Page Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Installing the Handset Battery Pack Setting up your PhoneExtending the Antenna BLK RED Cleaning the Battery Contacts Charging the Battery Pack Initial Battery ChargingContinuous Battery Charging Low Battery Indicator During a Call Standby ModeAdjusting Ringer/Volume Controls Setting the Tone/Pulse SwitchHandset Volume Controls Base Volume Controls Automatic Digital Code Security ExtendAPhone ExtendAPhone Using your XC3545 Making and Receiving CallsChanging Channels, Hold, Mute, and Flash TALK/BA LOW LED willWay Paging Using Page/IntercomPaging the Base Unit Transferring a Call Paging the HandsetTransferring a Call from the Handset INT’COM LEDTransferring a Call from the Base Room Monitor Feature To turn the monitor offStoring a Number in Memory Programming your PhoneHandset Operation Tone indicates that the number is stored Base Operation USE LED blinksPress Magain Enter the memory location Storing a Tone/Pulse Number With a Pulse Dial System 3300 Enter the number to be Tone indicates that the number is stored Storing One-Touch Dialing Numbers Channel Press M Tone indicates that the number is stored Dialing a Stored Number Chain DialingErasing a Stored Number Troubleshooting Problem SuggestionHandset XC3545 Precautions Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty Covered under one or more of the following U.S. patents