Uniden XC3545 important safety instructions Radio Interference, More Than One Cordless Telephone

Page 7

Radio Interference

Radio interference may occasionally cause buzzing and humming in your cordless Handset, or clicking noises in the Base Unit. This interference is caused by external sources such as TV, refrigerator, vacuum cleaner, fluorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If these noises continue and are too distracting, please check around your home to see what appliances may be causing the problem. In addition, we recommend that the Base not be plugged into a circuit that also powers a major appliance because of the potential for interference. Be certain that the antenna on the unit is fully extended when needed.

In the unlikely event that you consistently hear other voices or distracting transmissions on your phone, you may be receiving radio signals from another cordless telephone or other source of interference. If you cannot eliminate this type of interference, you need to change to a different channel.

Finally, it should be noted that some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs; to minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR; and, if interference is experienced, moving the cordless telephone farther away from the TV or VCR will often reduce or eliminate the interference.

More Than One Cordless Telephone

If you want to use more than one cordless telephone in your home, they must operate on different channels. Press the channel key to select a channel that provides the clearest communication.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Table of Contents Important Safety Instructions Page Introduction FeaturesIncluded with the XC3545 Important Electrical Considerations Telephone Line ProblemsRange More Than One Cordless Telephone Radio InterferenceSelecting a Location InstallationTelephone Line Outlets Applying Power to the Base Unit Connecting the Telephone CordsDesk or Tabletop Installation Adapter Safety FeaturePage Page Placement of the Handset Wall InstallationStandard Wall Plate Mounting Page Page Direct Wall Mounting Page Page Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Installing the Handset Battery Pack Setting up your PhoneExtending the Antenna BLK RED Cleaning the Battery Contacts Initial Battery Charging Charging the Battery PackContinuous Battery Charging During a Call Standby Mode Low Battery IndicatorAdjusting Ringer/Volume Controls Setting the Tone/Pulse SwitchHandset Volume Controls Base Volume Controls Automatic Digital Code Security ExtendAPhone ExtendAPhone Making and Receiving Calls Using your XC3545TALK/BA LOW LED will Changing Channels, Hold, Mute, and FlashWay Paging Using Page/IntercomPaging the Base Unit Paging the Handset Transferring a CallINT’COM LED Transferring a Call from the HandsetTransferring a Call from the Base To turn the monitor off Room Monitor FeatureStoring a Number in Memory Programming your PhoneHandset Operation Tone indicates that the number is stored USE LED blinks Base OperationPress Magain Enter the memory location Storing a Tone/Pulse Number With a Pulse Dial System 3300 Enter the number to be Tone indicates that the number is stored Storing One-Touch Dialing Numbers Channel Press M Tone indicates that the number is stored Chain Dialing Dialing a Stored NumberErasing a Stored Number Problem Suggestion TroubleshootingHandset XC3545 Precautions Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty Covered under one or more of the following U.S. patents
Top Page Image Contents