Uniden XC3545 important safety instructions Transferring a Call from the Base

Page 37

Transferring a Call from the Base

1.PressIon the Base.

The phone will begin to ring, and the IN USE LED will blink, indicating the call is on hold.

Note: f there is no answer, pressIagain to cancel.

2.JPressTor

on the

Handset to answer the page.

3.Announce there is a call waiting, and press I or Kto transfer.

Note: If you press Know, then a 3-way calling begins.

To end the conversation

4.After a call is transferred, pressTto end the call.

Note: o end a

K3-way call, press on the Base

andTon the Handset.

4

2 1,3

37

Image 37

Contents Table of Contents Important Safety Instructions Page Introduction FeaturesIncluded with the XC3545 Important Electrical Considerations Telephone Line ProblemsRange More Than One Cordless Telephone Radio InterferenceSelecting a Location InstallationTelephone Line Outlets Applying Power to the Base Unit Connecting the Telephone CordsDesk or Tabletop Installation Adapter Safety FeaturePage Page Placement of the Handset Wall InstallationStandard Wall Plate Mounting Page Page Direct Wall Mounting Page Page Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Installing the Handset Battery Pack Setting up your PhoneExtending the Antenna BLK RED Cleaning the Battery Contacts Initial Battery Charging Charging the Battery PackContinuous Battery Charging During a Call Standby Mode Low Battery IndicatorAdjusting Ringer/Volume Controls Setting the Tone/Pulse SwitchHandset Volume Controls Base Volume Controls Automatic Digital Code Security ExtendAPhone ExtendAPhone Making and Receiving Calls Using your XC3545TALK/BA LOW LED will Changing Channels, Hold, Mute, and FlashWay Paging Using Page/IntercomPaging the Base Unit Paging the Handset Transferring a CallINT’COM LED Transferring a Call from the HandsetTransferring a Call from the Base To turn the monitor off Room Monitor FeatureStoring a Number in Memory Programming your PhoneHandset Operation Tone indicates that the number is stored USE LED blinks Base OperationPress Magain Enter the memory location Storing a Tone/Pulse Number With a Pulse Dial System 3300 Enter the number to be Tone indicates that the number is stored Storing One-Touch Dialing Numbers Channel Press M Tone indicates that the number is stored Chain Dialing Dialing a Stored NumberErasing a Stored Number Problem Suggestion TroubleshootingHandset XC3545 Precautions Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty Covered under one or more of the following U.S. patents