Uniden XC3545 Programming your Phone, Storing a Number in Memory, Handset Operation

Page 39

Programming your Phone

For convenience, both the Handset and Base units have ten memory locations, so you can store the numbers you use most often in either place. Just remember that all programming must be completed when your phone is in the standby mode, since the programming keys will not function while you are on the phone.

Storing a Number in Memory

Handset Operation

Use these keys to store a number in memory with the Handset.

Note: An error tone will sound and the programming procedure will be cancelled if more than 20 seconds elapses between each keystroke entry or step.

TALKCHANNEL TALK

BATT LOW

ABC DEF

1 2 3

GHI JKL MNO

4 5 6

PRS TUV WXY

7 8 9

OPER

0

TONE

MEM 1 2 3

FLASH VOLUME

INT'C R.TONE R.VOL RDL/P

1.Remove the Handset from the Base Unit.

2.PressM.

The TALK/BATT LOW LED blinks.

3.Enter the number you want to store (up to 16 digits).

TALK

TALK

BATT LOW

ABC DEF

1 2 3

GHI JKL MNO

4 5 6

PRS TUV WXY

7 8 9

OPER

5551212

39

Image 39

Contents Table of Contents Important Safety Instructions Page Introduction FeaturesIncluded with the XC3545 Telephone Line Problems Important Electrical ConsiderationsRange More Than One Cordless Telephone Radio InterferenceInstallation Selecting a LocationTelephone Line Outlets Applying Power to the Base Unit Connecting the Telephone CordsDesk or Tabletop Installation Adapter Safety FeaturePage Page Wall Installation Placement of the HandsetStandard Wall Plate Mounting Page Page Direct Wall Mounting Page Page Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Setting up your Phone Installing the Handset Battery PackExtending the Antenna BLK RED Cleaning the Battery Contacts Initial Battery Charging Charging the Battery PackContinuous Battery Charging During a Call Standby Mode Low Battery IndicatorSetting the Tone/Pulse Switch Adjusting Ringer/Volume ControlsHandset Volume Controls Base Volume Controls Automatic Digital Code Security ExtendAPhone ExtendAPhone Making and Receiving Calls Using your XC3545TALK/BA LOW LED will Changing Channels, Hold, Mute, and FlashUsing Page/Intercom Way PagingPaging the Base Unit Paging the Handset Transferring a CallINT’COM LED Transferring a Call from the HandsetTransferring a Call from the Base To turn the monitor off Room Monitor FeatureProgramming your Phone Storing a Number in MemoryHandset Operation Tone indicates that the number is stored USE LED blinks Base OperationPress Magain Enter the memory location Storing a Tone/Pulse Number With a Pulse Dial System 3300 Enter the number to be Tone indicates that the number is stored Storing One-Touch Dialing Numbers Channel Press M Tone indicates that the number is stored Chain Dialing Dialing a Stored NumberErasing a Stored Number Problem Suggestion TroubleshootingHandset XC3545 Precautions Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty Covered under one or more of the following U.S. patents