Archos AV420 user manual Channel. Example Set to 3 if you need to choose a channel

the Infrared Emitter stuck to your device and turn your device on and off. Click this test button again and your device should change from on to off or off to on. If pressing this button does not turn on and off your device, try the next code for your device (step 3 above). If none of the codes work, check that the infrared emitter is directly over the infrared sensor on your tuner device.

Note: In some rare cases the ON/OFF functionality may not work.

Parameter	Description
Key: -/--	Set this to On if normally, you have to press this same key on
	your device’s remote control in order to select a channel.
Number of digits	Set the number of digits that your device can recognize for a
	channel. Example: Set to 3 if you need to choose a channel
	greater than channel 99.
Key: Enter	Set this to On if normally, you have to press the Enter key
	on your device’s remote control after you enter the channel
	number. Example: If you normally press 1, 3, Enter for
	channel 13, then you would need to set this parameter to On.
Key Delay	Change the delay between the emission of each digit of a
	channel. You may need to adjust this if the AV400 seems
	to send only half the digits of a channel or more digits of a
	channel. Example: Adjust the key delay and retest channel
	select if it sends channel 1 instead of 12 or sends 112 instead
	of 12.

25