By default, the video output is set to S-Video. But, you can choose one of the following connections if you prefer:
S-Video: | Default. Connect an S-Video cable from the S-Video interface on the |
| back of the NMP-500to the S-Video interface on the back of the display. |
DVI | Connect a DVI cable from the back of the NMP-500to the DVI interface |
| on the back of the display. |
VGA: | Using the DVI-VGA adapter included, connect a VGA cable from the VGA |
| interface on the back of the NMP-500to the VGA interface on the back of the |
| display (PDP or LCD). Note: do not use both a VGA connection and a YPbPr |
| connection at the same time. |
Component: | Using the S-Video/YPbPr adapter. |
Composite: | Using an RCA cable. |
Click the Show IP button shown below. The IP address appears on-screen momentarily then disappears after about four seconds. If the IP address does not appear, check that the NMP-500and the display are set to the same video output settings: i.e., S-Video to S-Video, or VGA to VGA, etc. To change the output setting, login to the NMP-500(Step 3) and select Management > Video/Audio for the screen shown below. For more information, see the Video/Audio Configuration section later in this guide.
Show IP