ViewSonic NMP-500 manual Put Batteries in Remote Control

1In the TV Mode field, click the down arrow for the pull-down menu and select one of the resolutions required by your display (PDP or LCD).

2Move the Brightness slider: values range between -128 and 127

3Move the Contrast slider: values range between 0 and 255

4Move the Saturation slider: values range between 0 and 255

5Move the Audio Channel Volume (left) slider: values range between 0 and 100

6Move the Audio Channel Volume (right) slider: values range between 0 and 100

7If any changes were made to this screen, do the following:

•To enable the changes, click Apply

•To save the changes, click the Administration menu > click Save Configuration > click Save.

5. Put Batteries in Remote Control

Remove the back cover from the remote control as shown below. Put two AA batteries in the battery compartment. Be sure to match the positive end of the battery with the positive end in the compartment. Put the cover back on the remote control.

ViewSonic NMP-500 9 of 38