Teac GF-350 owner manual For U.S.A, Type SF-W36FR Manufacturer Laser output

Page 3

WARNING : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

<DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN!

<IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN REPAIRED.

<USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the equipment and/or the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipments not expressly approved by TEAC CORPORATION for compliance will void the user’s warranty.

This product has been designed and manufactured according to FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968“, and is classified as class 1 laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings.

The label required in this regulation is shown .

For U.S.A.

Optical pickup :

 

Type

: SF-W36FR

Manufacturer

: SANYO ELECTRIC CO., LTD.

Laser output

: Less than 1 mW (Play) on the objective lens

 

Less than 5 mW (Record) on the objective lens

 

Less than 10 mW (Erase) on the objective lens

Wavelength

: 783 nm

 

 

CAUTION

The product shall not be exposed to dripping or splashing and that no object filled with liquids, such as vases, shall be placed on the product.

Do not install this equipment in a confined space such as a book case or similar unit.

ENGLISH

3

Image 3
Contents 9A10219000 GF-350Important Safety Instructions Type SF-W36FR Manufacturer Laser output For U.S.ABefore using the unit ContentsRemoving old stylus How to Replace the StylusInstalling a new stylus Handling RecordsCD-RCD-RW DiscsFinalizing Remote Control UnitBattery Installation About CD-R and CD-RW discsFM antenna AC Power CordPlug this AC power cord into an AC wall socket ConnectionsParts of the Turntable How to open/close the turntable coverP O N M L K J Unit Functions and Remote ControlPHONO/AUX, FM/AM, CD PowerVolume TuningAM broadcast Basic OperationListening to the Radio If the reception is poorGently open the dust cover Listening to a RecordPress the PHONO/AUX button once or twice to select PhonoGently lower the tone arm by slowly releasing the cue lever Turntable will begin to turnNo TOC CD-R Listening to a CDCD-R CD-RWTo skip to the next or a previous track To suspend playback temporarily pause modeTime Display To stop playbackRepeat 1 Repeat one track Repeat PlaybackShuffle Playback Repeat ALL Repeat All the TracksPress the Program button Press the Program button in the stop modeProgrammed Playback Press the Music Skip button . or / to select a trackBefore Recording 20db, -30db or -40db Auto REC RecordingLoad a recordable CD-R or CD-RW disc into the unit ManualPress the Stop button H to stop recording To suspend recording temporarily pause modeTo stop recording Manual track divisionFinalize Press the Play button y to start erasing or unfinalizing Erase or Unfinalize a CD-RWEr and the number of the last track recorded on the disc Er ALLTroubleshooting Specifications Error MessagesMessages NE PAS Déplacer L’APPAREIL Durant LA Lecture SommaireAvant l’utilisation AvertissementAvertissement Installation d’une nouvelle aiguilleManutention des disques Comment remlacer l’aiguilleDisques Mise en place des piles Boîtier de télécommandeRemarques concernant les disques compacts CD-R et CD-RW FinalisationPrécaution RaccordementsAntenne FM Cordon d’alimentationComment ouvrir/fermer le couvercle de la platine Nomenclatures des controles table tournanteNomenclatures des controles Affichage Indicateur Tuned Capteur de télécommandeEnceintes stéréo Touches de commande de CD Stop H Panneau d’affichage fréquenceTransmission AM Opération de baseÉcoute de la radio Si la réception est mauvaiseAttache Écoute de disque3visse Adapteur 45 RPM Déposez le disque sur la table tournanteLa table tournante commence à tourner Aucune mention Écoute de CDAppuyez sur la touche CD pour choisir CD Appuyez sur la touche OPEN/CLOSE L pour fermer le tiroirPour sauter au morceau suivant ou précédant Pour suspendre la lecture momentanément mode pauseAffichage du temps Pour arrêter la lectureRepeat 1 Répétition du morceau Lecture répétéeLecture aléatoire Repeat ALL Répétition de tout le disquePour supprimer le dernier morceau du programme Lecture ProgramméePour contrôler l’ordre programmé Pour ajouter un morceau à la fin du programmeAvant d’enregistrer Scms Système de gestion de copie en sérieRègle Appuyer sur la touche Record EnregistrementPour enregistrer à partir d’un disque vinyle, sélectionner 20db, -30db ou -40db Auto RECPour arrêter l’enregistrement, appuyer sur la touche Stop H Pour interrompre l’enregistrement temporairement mode pausePour arrêter l’enregistrement Division manuelle de morceauAppuyez sur la touche Finalize en mode arrêt FinalisationCette section concerne ce qui suit l’enregistrement Effacement ou dé-finalisation d’un CD-RW Er et le numéro du dernier morceau enregistré sur le disqueErALL Dépannage Spécifications Affichage des erreursGénéralités Model number Serial number Teac Corporation