Haier AD482AMEAA Malfunction, Unit fails to start, Cooling or heating is not sufficient

Page 8
Doesn't any obstacle exist at the air inlet or outlet?
Isn't the room much crowded?

Malfunction

please check the following things about your air conditioner before making a servie call.

Unit fails to start

Is the power source switch adjust cut in?

ON

OFF

Power supply switch is not ON.

Is city supply power in

Isn't the signal receiving

Isn't the earth leakage

normal?

section exposed to the

breaker in action?

 

direct sunlight or strong

 

 

illumination?

It is dangerous. Turn off

 

 

Power

 

the power supply switch

stoppage?

 

immediately and contact

 

 

 

 

the sales dealer.

 

Cooling or heating is not sufficient

 

 

Is the thermostat adjust

Isn't the air filter dirty? Isn't any doors or windows

as required?

left open?

Isn't the swing louver horizontal?

(At HEATING mode)

If swing louver is horizontal, the blow wind does not reach floor.

Cooling is not sufficient

Isn't sun-shine invading

Isn't any unexpected

 

direct?

heating load generated?

 

 

 

 

The wind does not blow during heating operation

Isn't it warming up?

When the air conditioner does not operate properly after you have checked the above mentioned items or when the following phenomenon is observed, stop the operation of the air conditioner and contact your sales dealer.

The fuse or breaker often shuts down.

Water drops off during cooling operation.

There is a irregularity in operation or abnormal sound is audible.

When the CHECK LED (red) flickers of wired controller, an irregularity has occurred in the air conditioner.

7

Image 8
Contents Duct Type AIR Conditioner Please keep this manual carefully and safelyTable of Contents Disposal of the old air conditioner Safety Precautions Circuit breaker may be necessary Positive drainingNeither stand on the air conditioner nor Machine is adaptive in following situation OutdoorParts and Functions Duct Air outlet Air inletMalfunction Unit fails to startCooling or heating is not sufficient Cooling is not sufficientCase of Auto mode, operation mode is changed automati Followings are not malfunctionWater flowing sound is heard This is caused by heat expansion or contraction of plasticsCare and Maintenance Points to observeFor Preparation of HeatingHot Keep Is The Unit Installed Correctly Installation placeWhen you change your address or the installation place For inspection and maintenanceInstallation Manual For Indoor Unit Serious injury are listedCombination 416mmPreparation of indoor unit Avoid installation and use at those places listed below Hanger bolts installationInstallation of indoor unit Adjusting to the levelnessTap selection on blower unit Drain PipingProcedures Drainage TestConnection of suction, exhaust ducts Installation work for air outlet ductsBlowout duct Wiring connection ModelRemarks Trouble ShootingShows resumable fault, shows it is not resumable fault Resumable if DegreeHaier Group