Installation Procedures
PREPARING INDOOR UNIT INSTALLATION
1.REMOVE THE INTAKE GRILL
Open the intake grill and remove the three or four or six screws.(Fig. 1)
Fig. 1
Intake grill
A.FLOOR CONSOLE TYPE
1.DRILLING FOR PIPING
Select piping and drain directions.(Fig.2) The piping and drain can be made in three directions as shown below.
Remark:
The main unit can be wired before the indoor unit is installed. Select the most appropriate installation order.
When the directions are selected, drill a 7 cm dia. hole on the wall so that the hole is tilted downward toward the outdoor for smooth water flow. When the pipe is led out from the rear, make a hole in Fig.4, at the position shown.
(Fig.2) |
| (Fig.4) |
|
|
| Wall |
|
|
|
| 6mm |
| rear | 7cm |
|
|
|
| |
| right | Indoor unit | outdoor unit |
|
|
| |
| down |
|
|
The drain hose can be connected to either the | When installing set to wall, install the accessory wall | |
bracket at the position shown in Fig.5,and mount the | ||
left or right side.(Fig.3) | ||
set to it. | ||
|
(Fig. 3) | (Fig. 5) |
65.5cm | 53cm | 4.5cm |
Drain hose (Left side) | Drain hose (Right side) |
99cm
50cm 24.5cm
Wall bracket
Side of set
6.5cm |
|
|
7cm hole | 6.5cm | |
3.5cm hole |
| |
12.5cm | 10cm |
|
9