Haier AC242ACEAA, AC182ACEAA, AC142ACERA, AC142ACEAA Trouble Shooting, Followings are not problems

Page 19

Trouble Shooting

Followings are not problems

Sound of water flowing is

During unit operation or at stop, a swishing or

not a problem.

gurgling noise may be heard. This noise is generated

 

by refrigerant flowing in the system.

Sound of cracking is heard.

During unit operation, a cracking noise may be heard.

 

This noise is generated by the casing expanding or

 

shrinking because of temperature changes.

Smell are generated.

This is because the system circulates smells from the

 

interior air such as the smell of cigarettes or the

 

painting on the furniture.

During operation, white fog or steam

When unit is running at places like restaurant, etc. where

comes out from the indoor unit.

dense edible oil fumes always exist, this will happen.

In cooling operation, unit switches to

To prevent frost from accumulating on indoor heat

blowing operation.

exchanger, unit will switch to blowing operation for a

 

while then resume cooling operation.

Unit will not restart after stop.

Though ON/OFF button is set

 

to ON, unit won't resume cooling,

Won't start?

dry or heating operation

in 3 min after it is stopped, this

 

is because of 3-min-delay

 

protection circuit.

 

Please wait 3 minutes

No outlet air or fan speed can't be changed

Unit will reduce fan speed repeatedly and automatically

in dry mode.

if room temp. is too low in dry operation.

In heating operation, water or steam are

This occurs when frost accumulated on the outdoor

blown out of outdoor unit.

unit is removed.

 

(during defrosting operation)

In heating operation, indoor fan won't stop even if unit is stopped.

After unit stop, indoor fan will go on running until indoor unit cools down.

17

Image 19
Contents Operation & Installation Manual Contents Disposal of the old air conditioner DB C WB C Maximum Minimum IndoorDB C WB CSafety Precautions Indoor Unit Name of PartsCleaning the Air Filter Cleaning and CareDrain hose Operation TipsPiping hole cover Location InstallationSelecting the Mounting Position Installation ProceduresWall 6mm Rear 7cm Right Indoor unit Preparing Indoor Unit InstallationFloor Console Type Drilling for PipingDrain pan Drain hose Insulation Drain hose Installing Drain HoseUnder Ceiling Type Drain pan Nylon fastener Drain hoseWith a concrete drill, drill four 12.7 mm dia. Holes Installing BracketsSelect piping and drain directions WallInstall the Drain Hose Connecting the PipingFlare Processing Round terminal InsulationIndoor Unit Side Electrical WiringElectrical Requirement Customer Guidance Electrical WiringMount the Cover Plate Intake Grill Check ItemsMount the intake grill Followings are not problems Trouble ShootingPoor cooling or heating Error display For *.ERA Error display For *.EAA Haier Group