Haier AC242ACEAA, AC182ACEAA, AC142ACERA, AC142ACEAA Cleaning and Care, Cleaning the Air Filter

Page 7

Cleaning and Care

CAUTION!

Before cleaning the air conditioner ,be sure to turn it off and disconnect

 

the Power Supply Cord.

 

 

Be sure the Intake Grill is installed securely.

 

When removing and replacing the air filters, be sure not to touch the heat

 

exchanger, as personal injury may result.

Cleaning the Air Filter

Open the Intake Grill

1.Pull out both sides and the center of the Intake Grill.

4.Re-attach the Air Filters to the Intake Grill.

1The Filters fit onto the inside of the intake Grill. (figure 1)

2The bottom edges of the Air Filters should fit into the filter brackets. (figure 1)

3The Air Filters should be pushed down so that their top edges fit under the projections at the top of the Intake Grill. (figure 2)

 

 

Air Filter

 

About 30 mm

Side Panel

 

(Figure 2)

Hook

(Figure 1)

 

 

 

 

Notch

 

 

 

Arm

Filter bracket

 

 

 

 

Arm

 

 

 

 

Intake Grill

 

 

2.Pull the Air Filters upward to remove them.

5.Push in both sides and the center of the Intake Grill.

Push the Air Filter handles away from the Intake Grille in direction as illustrated, then pull out Air Filters.

Air Filter

Bracket

Base

Handle

3.Clean the Air Filters.

Remove the dust from the Air Filters by vacuum cleaner or washing them. After washing, allow the Air Filters to dry thoroughly in an area protected from sunlight.

Dust can be cleaned from the Air Filter either with a vacuum cleaner, or by washing the filter in a solution of mild detergent and warm water. If you wash the filter, be sure to allow it to dry thoroughly in a shady place before reinstalling.

If dirt is allowed to accumulate on the Air Filter, air flow will be reduced, lowering operating efficiency and increasing noise. During periods of normal use, the Air Filters should be cleaned every two weeks.

5

Image 7
Contents Operation & Installation Manual Contents Disposal of the old air conditioner DB C WB C Maximum Minimum IndoorDB C WB CSafety Precautions Indoor Unit Name of PartsCleaning the Air Filter Cleaning and CareDrain hose Operation TipsPiping hole cover Location InstallationSelecting the Mounting Position Installation ProceduresWall 6mm Rear 7cm Right Indoor unit Preparing Indoor Unit InstallationFloor Console Type Drilling for PipingDrain pan Drain hose Insulation Drain hose Installing Drain HoseUnder Ceiling Type Drain pan Nylon fastener Drain hoseWith a concrete drill, drill four 12.7 mm dia. Holes Installing BracketsSelect piping and drain directions WallInstall the Drain Hose Connecting the PipingFlare Processing Round terminal InsulationIndoor Unit Side Electrical WiringElectrical Requirement Customer Guidance Electrical WiringMount the Cover Plate Intake Grill Check ItemsMount the intake grill Followings are not problems Trouble ShootingPoor cooling or heating Error display For *.ERA Error display For *.EAA Haier Group