Haier AC142ACEAA, AC182ACEAA, AC142ACERA, AC242ACEAA installation manual Name of Parts, Indoor Unit

Page 6

Name of Parts

10 11

Fig.1

1Operating Control Panel (Fig.2)

2Emergency switch

3Remote Control Signal Receiver

4Power Indicator Lamp (Red)

5OPERATION Indicator Lamp (Green)

6TIMER Indicator Lamp (Yellow)

7Compressor Run Lamp (Green)

8Intake Grill

9Air Filter

10UP/DOWN Air Direction Flaps

11RIGHT/LEFT Air Direction Louvers (behind UP/DOWN Air Direction Flaps)

POWER 4

OPER 5

TIMER 6

COMP 7

EMER 2

Fig.23

Fig.1 Indoor Unit

Note : For the wired control type unit, the unit state should be checked by the the wired controller, instead of the remote receiver; and if you set the TIMER function, the TIMER LED on the remote receiver will not be on.

Image 6

Contents Operation & Installation Manual Contents Disposal of the old air conditioner WB C Maximum Minimum IndoorDB C DB C WB CSafety Precautions Name of Parts Indoor UnitCleaning and Care Cleaning the Air FilterOperation Tips Drain hosePiping hole cover Installation LocationInstallation Procedures Selecting the Mounting PositionDrilling for Piping Preparing Indoor Unit InstallationFloor Console Type Wall 6mm Rear 7cm Right Indoor unitDrain pan Nylon fastener Drain hose Installing Drain HoseUnder Ceiling Type Drain pan Drain hose Insulation Drain hoseWall Installing BracketsSelect piping and drain directions With a concrete drill, drill four 12.7 mm dia. HolesConnecting the Piping Install the Drain HoseFlare Processing Insulation Round terminalElectrical Wiring Indoor Unit SideElectrical Requirement Check Items Electrical WiringMount the Cover Plate Intake Grill Customer GuidanceMount the intake grill Trouble Shooting Followings are not problemsPoor cooling or heating Error display For *.ERA Error display For *.EAA Haier Group