Haier HDU-18CF03, HDU-18HF03 Press Timer button to change Timer mode, 3Time setting for Timer on

Page 13

Operation

TIMER ON-OFF

(1)After unit start, select your desired operation mode

Operation mode will be displayed on LCD. Power indicator lights up.

(2)Press TIMER button to change TIMER mode

Every time the button is pressed, display changes as follows:

	ON	OFF	ON	blank
			OFF

Select OFFON .

(3)Time setting for TIMER ON

Press TIME button.

Every time the button is pressed, time increases 10min. If button is kept depressed, time will change quickly.

Every time the button is pressed, time decreases 10min. If button is kept depressed, time will change quickly. Time will be shown on LCD.

It can be adjusted within 24hours.

AM refers to morning and PM to afternoon.

HEALTH

HEAT

(4) Time confirming for TIMER ON

After time setting, press TIMER button to confirm. "ON" stops blinking, While "OFF" starts blinking.

Time displayed: Unit starts at Xhour X min.

(5)Time setting for TIMER OFF

Follow the same procedures in "Time setting for TIMER ON".

(6)Time confirming for TIMER OFF

After time setting, press SET button to confirm "OFF" stops flashing.

Time displayed: Unit stops at X hour X min.

To cancel TIMER mode

Just press TIMER button several times until TIMER mode disappears.

According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or Stop-Start can be achieved.

12

Image 13

Contents Duct Type AIR Conditioner Table of Contents Disposal of the old air conditioner Make sure the system is grounded Safety PrecautionsDo not wash the air conditioner with water Cooling Rated Maximum Minimum IndoorOutdoor Heating IndoorParts and Functions Parts and Functions Operation Power ON/OFFCool Fan operation Auto RUN, COOL,HEAT and DRY operation 2TIMER mode selection 1After unit start, select your desired operation mode3Timer setting 4Confirming your setting3Time setting for Timer on Press Timer button to change Timer modeTime confirming for Timer on 5Time setting for Timer OFFCooling, dehumidifying mode Heating mode This series changeover switch is set 1. on 2.OFF 3.OFF 4.OFF Unit fails to start MalfunctionMalfunction Followings are not malfunction Points to observe Care and MalntenanceFor Preparation of HeatingHot Keep When heating is startedInstallation place Is The Unit Installed CorrectlyInstall wire controller Installation Manual For Wire ControllerIndoor unit wiring Safety precautions Installation Manual For Indoor UnitIndoor unit Installation Manual For Indoor Unit Sketch map of long duct Installation of air return duct Installation of air sending ductThermal insulation of duct Foundation bolt Pipe and insulation material RequirementsHose Supplementary refrigerant Allowable pipe length and drop Pipe material and sizeConnection of refrigerant pipe Open all valves Vacuum pumpingGas leakage detection Electric wiring Haier Group