Haier HDU-18HF03, HDU-18CF03, HDU-28CF03 Is The Unit Installed Correctly, Installation place

Page 21

Is The Unit Installed Correctly

Confirm the following items for safe and comfortable use of air conditioner.

The installation work is to be burden on the sales dealer, and do not conduct it by yourself.

Installation place

Avoid installing the air conditioner

Install the unit at well ventilated

Install the air conditioner firmly on

near the place where possibility of

place.

the foundation that can fully support

inflammable gas leakage exists.

 

 

 

the weight of the unit.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Explosion (Ignition) may occur.

If some obstacle exist, it may cause

If not, it may cause vibration or noise.

 

capacity reduction or noise increase.

 

Select the place so as not to annoy

Snow protection work is necessary

It is advisable not to install the air con-

neighbor with the hot air or noise.

where outdoor unit is blocked up

ditioner at the following special place.

 

by snow.

It may cause malfunction, consult the

 

 

sales dealer when you have to install

 

 

the unit on such a place.

 

 

The place where corrosive gas generates

 

 

(Hot spring area etc.)

 

 

The place where salt breeze blows

 

 

(Seaside etc.)

 

 

The place where dense soot smoke exists

 

 

The place where humidity is extraordina-

 

 

rily high

 

 

The place where near the machine which

 

For details consult your sales dealer.

radiates the electromagnetic wave

 

The place where voltage variation is con-

 

 

siderably large

Electric work

The electric work must be burden on the authorized engineer with qualification for electric work and grounding work, and the work must be conducted in accordance with electric equipment technical standard.

The power source for the unit is to be of exclusive use.

An earth leakage breaker should be installed.(This is necessary to prevent electric shock.) The unit must be grounded.

When you change your address or the installation place

Special technology is required for removal or reinstallation of air conditioner, consult the sales dealer. Besides, construction expense is charged for removal or reinstallation.

For inspection and maintenance

The capacity of air conditioner will decrease by contamination of inside of unit when it is used for about three years although depending upon the circumstances under which it is used, and so in addition to the usual maintenance service, special inspection/maintenance service is necessary. It is recommended to make a maintenance contract (charged) by consulting your sales dealer.

20

Image 21
Contents Duct Type AIR Conditioner Table of Contents Disposal of the old air conditioner Make sure the system is grounded Safety PrecautionsDo not wash the air conditioner with water Cooling Rated Maximum Minimum IndoorOutdoor Heating IndoorParts and Functions Parts and Functions Operation Power ON/OFFCool Fan operation Auto RUN, COOL,HEAT and DRY operation 2TIMER mode selection 1After unit start, select your desired operation mode3Timer setting 4Confirming your setting3Time setting for Timer on Press Timer button to change Timer modeTime confirming for Timer on 5Time setting for Timer OFFCooling, dehumidifying mode Heating mode This series changeover switch is set 1. on 2.OFF 3.OFF 4.OFF Unit fails to start MalfunctionMalfunction Followings are not malfunction Points to observe Care and MalntenanceFor Preparation of HeatingHot Keep When heating is startedInstallation place Is The Unit Installed CorrectlyInstall wire controller Installation Manual For Wire ControllerIndoor unit wiring Safety precautions Installation Manual For Indoor UnitIndoor unit Installation Manual For Indoor Unit Sketch map of long duct Installation of air sending duct Installation of air return ductThermal insulation of duct Foundation bolt Requirements Pipe and insulation materialHose Allowable pipe length and drop Pipe material and size Supplementary refrigerantConnection of refrigerant pipe Vacuum pumping Open all valvesGas leakage detection Electric wiring Haier Group