Roof Curb Installation (cont.)
Product Specifications
Curb installations must comply with local codes and should follow the established guidelines of the National Roofing Contractors Association.
Proper unit installation requires that the roof curb be firmly and permanently attached to the roof structure. Check for adequate fastening method prior to setting the unit on the curb.
Full perimeter roof curbs are available from the factory and are shipped unassembled. The installing contractor is responsible for field assembly, squaring, leveling, and mounting on the roof structure. All required hardware necessary for the assembly of the sheet metal curb is included in the curb accessory package.
•Determine sufficient structural support before locating and mounting the curb and package unit.
•
3-D View
92¼
15⅜ x 31⅛
Supply Opening
14⅝ x 38⅜
Return Opening
53¼
1⅝
¾
14
•Contractor furnishes curb insulation, cant strips,
flashing, and general roofing material.
•Support curbs on parallel sides with roof members. To prevent damage to the unit, the roof members cannot penetrate supply and return duct openings.
Note: The unit and curb accessories are designed to allow vertical duct installation before unit placement.
14 Duct installation after unit placement is not recommended.
See the manual shipped with the roof curb for assembly and installation instructions.
Top View
1⅜
Power Wiring
Thermostat
Wiring
Power and
www.goodmanmfg.com | 29 |