Product Specifications
Unit Clearances
Maintain an adequate clearance around the unit for safety, service, maintenance, and proper unit operation. Leave a total clearance of 75” on the main control panel side of the unit for possible removal of fan shaft, coil, electric heat, and gas furnace. Leave a clearance of 48” on all other sides of the unit for possible compressor removal or service access, and to ensure proper ventilation
and condenser airflow. Do not install the unit beneath any obstruct- ion. Install the unit away from all building exhausts to inhibit ingestion of exhaust air into the unit’s
48”
48”
36” Min.
75” 48”
Electrical Entrance Locations
Dimples Mark Drill Locations
11⅝”
103/16”
3”
www.goodmanmfg.com | 27 |