Using the Table Stand | La Crosse Technology WS-7078TWC manual

1.Using the Table Stand

a.The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor weather station in an appropriate location.

2.WALL MOUNTING

a.Remove the table-stand. To do this, pull down on the stand from the rear and rotate forward.

b.Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall.

c.Place the indoor weather station onto the screw using the hanging hole on the backside. Gently pull the indoor weather station down to lock the screw into place.

TROUBLESHOOTING

Problem: No reception of WWVB time signal.

Solution: 1) Wait overnight for signal.

2)Be sure indoor weather station is at least 6 feet from any electrical devices, such as televisions, computers, or other radio-controlled clocks.

3)Remove batteries for five minutes, reinsert and leave the unit alone overnight without pressing buttons.

4)If there are still problems, contact La Crosse Technology

Problem: Hour is incorrect (minute and date are correct)

Solution: Be sure correct time zone and daylight saving time are selected.

Problem: The LCD is faint

Solution: 1) Set the LCD contrast to a higher number 2) Replace batteries

Problem: No outdoor temperature is displayed.

Solution: 1) Remove all batteries, reinsert into remote thermo/hygro sensor first, then indoor weather station.