3.Press and release the “SET” button twelve more times to advance to the Relative Pressure setting.
4.The barometric air pressure will flash in the middle of the display, just below the forecast icon
5.Press and release the “OUT/+” or “IN” button to select the desired relative air pressure value.
6.Press and release the “SET” button to confirm the relative pressure setting and continue to the Forecast Sensitivity setting.
O.Forecast Sensitivity Setting
1.Press and hold the “SET” button for five seconds.
2.“lcd” will appear at the top of the display and a number will flash next to it.
3.Press and release the “SET” button thirteen more times to advance to the Forecast sensitivity setting.
4.The two air pressure tendency arrows will begin flashing on either side of the forecast icon and a flashing number will appear under the forecast icon.
5.Press and release the “OUT/+” button to select the desired forecast sensitivity setting.
Note: Barometric air pressure is usually reported as “relative air pressure”. This reading is based on the combination of absolute air pressure and altitude. In general, an increase in altitude will result in a decrease in air pressure. Relative air pressure will make readings in nearby locations relative to each other to allow for proper forecasting. The absolute air pressure reading in the Weather Center cannot be calibrated, only the relative air pressure.
6.Press and release the “SET” button to confirm the forecast sensitivity setting.
THE MANUAL SETTING IS NOW COMPLETED
13