La Crosse Technology WS-7394U-IT VII. Mounting, Mounting the Remote Temperature Sensor

Note:

For accurate barometric pressure trends, the Weather Station should operate at the same altitude for example, it should not be moved from the ground to the second floor of the house. Should the unit be moved to a new location, discard readings for the next 48-60 hours.

This feature cannot be turned off.

VII. MOUNTING

Note: Before permanently mounting, ensure that the Wireless Weather Station is able to receive signals from the sensors and WWVB signal at the desired location. To achieve a true temperature reading, avoid mounting the remote temperature sensor (or any sensor) where direct sunlight can reach the remote sensor. We recommend that you mount the remote sensor on a North-facing wall or under an eve. The sending range of the remote temperature sensor is 330-ft (100m) however obstacles such as walls, concrete, and large metal objects can reduce the range. Place all units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. If the Wireless Weather Station loses the signal from the remote sensor, it will display the last temperature reading for 15 minutes. After 15 minutes of not receiving any signals, the remote temperature will display “- -

.-”.

A.Mounting the Remote Temperature Sensor

The remote temperature sensor can be mounted in two ways:

•with the use of screws

•using the adhesive tape

1.MOUNTING WITH SCREWS

a. Remove the mounting bracket from the remote temperature sensor.

b.Place the mounting bracket over the desired location.

c.Through the three screw holes of the bracket, mark the mounting surface with a pencil.

d.Screw mounting bracket onto the mounting surface.

Ensure that the screws are flush with the bracket.

e. Insert the remote temperature sensor into the bracket.

2.MOUNTING WITH ADHESIVE TAPE

18