La Crosse Technology WS-7394U-IT Detailed SET-UP Guide, Remote Temperature Sensor

Page 5

DETAILED SET-UP GUIDE

I.BATTERY INSTALLATION (When one temperature sensor is being used)

1.First, insert the batteries to the temperature sensor (see “A. Remote Temperature Sensor” below).

2.Within 2 minutes of powering up the sensor, insert the batteries to the Weather Station (see “B. Wireless Weather Station” below). Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature and humidity, and the time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is displayed user may proceed to the next step.

3.After the batteries are inserted, the Weather Station will start receiving data signal from the sensor. The outdoor temperature should then be displayed on the Weather Station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1 and the signal reception icon is no longer shown.

A. Remote Temperature Sensor

 

1.

Remove the mounting bracket. The bracket snaps

 

 

on and off easily.

Battery

2.

Remove the battery cover, by sliding the cover

Cover

 

down.

 

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

B. Wireless Weather Station

1.Remove the battery cover (the cover has white writing on it).

2.Observe the correct polarity, and install two Alkaline AA batteries.

3.Do not press any buttons for at least ten minutes. If a button is pressed before the indoor weather station has received information from the TX29U-IT sensor, no data will be received from that sensor until reset.

4.Replace the battery cover.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents WS-7394U-IT Wireless 915 MHz Wireless Weather Station Table of Contents This product offers Inventory of ContentsWeather Station Quick SET-UP GuideDetailed SET-UP Guide Remote Temperature SensorWireless Weather Station Wwvb Reception II. Start Up Sequence Initial StartIII. Explanation of LCD Information Overview of programming mode sequence Program ModeLCD Contrast Setting IV. Function Key LayoutRadio-Controlled Time ON/OFF Setting Time Zone SettingDST ON/OFF Setting Setting The Hour Manually 12/24-hour Time ModeSetting The Year Manually Setting The Minutes ManuallySetting The Month Manually Setting The Date ManuallyAir Pressure Measuring Units Selection inHg/hPa Temperature Measuring Units Selection F or CRelative Pressure Setting Manual Setting is NOW Completed Forecast Sensitivity SettingOutdoor Minimum and Maximum Temperature Features and OperationsViewing and Operating with Multiple Remote Sensors Multiple Remote Temperature SensorsWeather Icons Comfort Indicator for Indoor Temperature and HumidityWeather Forecast Icon and Pressure Trend Indicators Barometric Air Pressure Reading Air Pressure History Bar ChartWeather Tendency Arrows VII. Mounting Mounting the Remote Temperature SensorMounting with Screws Mounting with Adhesive TapeUsing the Table Stand Mounting the WS-7394U-IT Wireless Weather StationMaintenance and Care Instructions Wall MountingProblem TroubleshootingSolution SpecificationsPower supply Sensor reading update within sensorRelative humidity range Air pressurePage FCC ID OMOTX29U sensor RF Exposure mobile WS-7013U-IT Table of Contents Inventory of Contents Quick Setup Do not Press ANY Buttons for Minutes Page Page Detailed Setup Guide Remote Temperature Sensor Remove the mounting Page Page Setting the Time Features Page Page Page To wall mount MountingTroubleshooting Solution Maintenance and Care Measuring Temperatures SpecificationsDimensions H x W x D Warranty InformationPage Page Page Fax Mail Support@lacrossetechnology.com Warranty work Web FCC ID OMOTX29U sensor RF Exposure mobile
Top Page Image Contents