English
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME is not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Power cord not securely connected
• Connect AC power cord properly
–Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Display does not function properly/ No
reaction to operation of any of the controls
– Electrostatic discharge
•Switch off set, disconnect the power plug and reconnect after a few seconds
CD playback does not work
– CD is badly scratched/ dirty
• Replace/ clean CD (see MAINTENANCE)
– Laser lens steamed up
• Wait until lens has acclimatized
The CD skips tracks
–CD is damaged or dirty
• Replace or clean the CD
–SHUFFLE or a program is active
• Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see maintenance
– Use of incompatible cassette types (METAL or CHROME).
• Only use NORMAL (IEC I) for recording.
Recording does not work
– Cassette tab(s) may be broken
•Apply a piece of adhesive tape over the missing tab space.
Remote control does not function properly
–Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
–Distance between the set too large
• Reduce the distance
Environmental information
All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment.
18