EMC CX300, CX500, CX700 manual Clear the check box Use another port if busy

Page 11

Setting Up the Service Laptop

7.Clear the check box Use another port if busy.

8.Click the Server tab.

9.Set the Dial-up server type to be PPP: Windows NT, Windows 95 Plus, Internet.

10.In the Network Protocols dialog box, select TCP/IP.

11.Click TCP/IP Settings... and do the following in the PPP TCP/IP Settings dialog box:

a.Select the Server assigned IP address option.

The SP will provide the address for the service laptop.

b.Select the Server assigned name server addresses check box.

c.Select the Use IP header compression check box.

d.Click OK to exit the TCP/IP Settings... dialog box.

12.Set Enable software compression to on.

13.Set Enable PPP LCP extensions to on.

14.Click the Security tab.

15.Set Accept any authentication including clear text to on.

16.Click OK to exit the Security dialog box.

17.Click Close to exit the Dial-up Networking dialog box and save your settings.

18.To verify the Domain name, do the following:

a.Double-click My Computer, then double-click Dial-Up Networking.

b.Double-click Network.

c.In the Network dialog box, click the Identification tab.

d.The Domain field should be Workgroup. If it is not, click the Change button and select Workgroup.

e.Click the Workgroup radio button, then click OK.

f.In the Network dialog box, click OK.

What Next? The service laptop is ready to initialize a storage processor. Refer to Initializing the Storage System on page 12.

EMC CLARiiON CX300, CX500, and CX700 Initialization Guide

11

Image 11

Contents EMC CLARiiON CX300, CX500, and CX700 Storage Systems Initialization GuideHost Initialization OverviewRequirements for Initial Setup Service Laptop Requirements Physical Modem Setting Up the Service LaptopSelect Dont Detect my Modem I will select it from a list Setting Up the Dial-Up PPP Support Windows 2000 EnvironmentClick Properties Setting Up Dial-Up Networking Windows 2000 EnvironmentNetwork Connection Wizard opens Click Connect directly to another computer, then click NextClick the Networking tab Highlight Dialup Networking S... and click Properties Start Settings Control Panel ModemsSet the Initial speed bps to Setting Up Dial-Up Networking Windows NT 4.0 EnvironmentClick Configure Select the Server assigned IP address option Set Accept any authentication including clear text to onClear the check box Use another port if busy SP a SP B Initializing the Storage SystemInitialization Steps Turn the service laptop onOn the laptop, select My Computer Dial-up Networking For WindowsStorage Processor Networking Configuration Setup Screen SP a You will set security in a later step Network Configuration Confirmation Screen SP a On the laptop, select My Computer Dial-up Networking Storage Processor Networking Configuration Setup Screen SP B Click Apply Settings Network Configuration Confirmation Screen SP B SP Properties screen opens, as shown in Figure SP B Properties Confirm SP B SP Properties dialog box opensSetting the Port Speed Remove the Null modem cable from SP B and connect it On the laptop, select My Computer Dial-up Networking EMC CLARiiON CX300, CX500, and CX700 Initialization Guide Changing the Default Battery Test Time Setting Battery Test TimeConnecting the Service Laptop to the SP LAN Port Installing Optional Navisphere 6.X SoftwareMirrorViewUI SnapViewUI SANCopyUI AnalyzerUI Installing Software OptionsStorage System Properties dialog box opens 10.42.12.1002162/setup Setting Initial Security Parameters192.168.1.1/setup Using the Serial Cable Via the Serial Port Alternate MethodLAN Making Management and Switch or Host ConnectionsConnecting the Fibre-optic Switch/Host Cables CX700 Shown Connecting a Fibre-Optic Switch or Fibre Channel HostTrademark Information Configuring Your Host Server and Storage System