EMC CX500, CX700, CX300 Installing Software Options, MirrorViewUI SnapViewUI SANCopyUI AnalyzerUI

Page 30

Installing Optional Navisphere 6.X Software

3.On the laptop desktop, enter an IP address, subnet mask, and default gateway for your connection. Be sure the IP address is unique to this connection.

You can enter the same mask and gateway specified in step 12 on page 20, but you must assign an IP address not used by SP A or B; for example, 10.4.12.138 rather than 136 or 137.

4.Open the PPP connection icon on your desktop taskbar, and disconnect the laptop-array serial connection.

Installing Software Options

To install software do the following:

1.If you plan to use Navisphere Manager, MirrorView, SnapView, SAN Copy, Analyzer, or Access Logix software, use the LAN connection to install the appropriate files listed below from the Navisphere Manager CD-ROM and the Access Logix CD-ROM. Install them as part of the same software installation, as described in the Navisphere Manager online help (refer to the section on Installing software packages).

•ManagementUI (required for Manager)

•MirrorViewUI

•SnapViewUI

•SANCopyUI

•AnalyzerUI

•File on your Access Logix CD-ROM

All the UIs listed above are on the Navisphere Manager CD-ROM.

2.If you have SnapView, MirrorView, SAN Copy, or Analyzer software, install those drivers from the SnapView, MirrorView, SAN Copy, or Analyzer CD-ROM in a subsequent software installation.

30

EMC CLARiiON CX300, CX500, and CX700 Initialization Guide

Image 30

Contents Initialization Guide EMC CLARiiON CX300, CX500, and CX700 Storage SystemsInitialization Overview HostRequirements for Initial Setup Service Laptop Requirements Setting Up the Service Laptop Physical ModemSetting Up the Dial-Up PPP Support Windows 2000 Environment Select Dont Detect my Modem I will select it from a listClick Connect directly to another computer, then click Next Setting Up Dial-Up Networking Windows 2000 EnvironmentNetwork Connection Wizard opens Click PropertiesClick the Networking tab Start Settings Control Panel Modems Highlight Dialup Networking S... and click PropertiesSetting Up Dial-Up Networking Windows NT 4.0 Environment Click ConfigureSet the Initial speed bps to Set Accept any authentication including clear text to on Clear the check box Use another port if busySelect the Server assigned IP address option Initializing the Storage System SP a SP BTurn the service laptop on Initialization StepsFor Windows On the laptop, select My Computer Dial-up NetworkingStorage Processor Networking Configuration Setup Screen SP a You will set security in a later step Network Configuration Confirmation Screen SP a On the laptop, select My Computer Dial-up Networking Storage Processor Networking Configuration Setup Screen SP B Click Apply Settings Network Configuration Confirmation Screen SP B SP Properties screen opens, as shown in Figure Confirm SP B SP Properties dialog box opens SP B PropertiesSetting the Port Speed Remove the Null modem cable from SP B and connect it On the laptop, select My Computer Dial-up Networking EMC CLARiiON CX300, CX500, and CX700 Initialization Guide Setting Battery Test Time Changing the Default Battery Test TimeInstalling Optional Navisphere 6.X Software Connecting the Service Laptop to the SP LAN PortInstalling Software Options MirrorViewUI SnapViewUI SANCopyUI AnalyzerUIStorage System Properties dialog box opens Setting Initial Security Parameters 10.42.12.1002162/setupUsing the Serial Cable Via the Serial Port Alternate Method 192.168.1.1/setupMaking Management and Switch or Host Connections LANConnecting a Fibre-Optic Switch or Fibre Channel Host Connecting the Fibre-optic Switch/Host Cables CX700 ShownConfiguring Your Host Server and Storage System Trademark Information