EMC CX300, CX500, CX700 manual Click the Networking tab

Page 8

Setting Up the Service Laptop

15.Click the Networking tab.

PPP:Windows 95/98/NT 4/2000, Internet should appear in the Type of dial-up server I am calling list.

16.Click Settings.

17.Make sure that Enable LCP extensions and Enable software compression are checked, then click OK.

18.Highlight Internet Protocol (TCP/IP).

19.Click Properties.

20.Select Obtain an IP address automatically and Obtain DNS server address automatically.

21.Click Advanced. Make sure that Use IP header compression is checked. Deselect Use default gateway on remote network.

22.Click OK three times to bring you back to the Connect CX700init dialog box.

23.Click Cancel to close the Connect CX700init dialog box. You will enter a user name and password when you initialize the storage system at the customer site.

What Next? The service laptop is ready to initialize a storage processor at the customer site. Refer to Initializing the Storage System on page 12.

8

EMC CLARiiON CX300, CX500, and CX700 Initialization Guide

Image 8

Contents Initialization Guide EMC CLARiiON CX300, CX500, and CX700 Storage SystemsInitialization Overview HostRequirements for Initial Setup Service Laptop Requirements Setting Up the Service Laptop Physical ModemSetting Up the Dial-Up PPP Support Windows 2000 Environment Select Dont Detect my Modem I will select it from a listSetting Up Dial-Up Networking Windows 2000 Environment Network Connection Wizard opensClick Connect directly to another computer, then click Next Click PropertiesClick the Networking tab Start Settings Control Panel Modems Highlight Dialup Networking S... and click PropertiesSet the Initial speed bps to Setting Up Dial-Up Networking Windows NT 4.0 EnvironmentClick Configure Select the Server assigned IP address option Set Accept any authentication including clear text to onClear the check box Use another port if busy Initializing the Storage System SP a SP BTurn the service laptop on Initialization StepsFor Windows On the laptop, select My Computer Dial-up NetworkingStorage Processor Networking Configuration Setup Screen SP a You will set security in a later step Network Configuration Confirmation Screen SP a On the laptop, select My Computer Dial-up Networking Storage Processor Networking Configuration Setup Screen SP B Click Apply Settings Network Configuration Confirmation Screen SP B SP Properties screen opens, as shown in Figure Confirm SP B SP Properties dialog box opens SP B PropertiesSetting the Port Speed Remove the Null modem cable from SP B and connect it On the laptop, select My Computer Dial-up Networking EMC CLARiiON CX300, CX500, and CX700 Initialization Guide Setting Battery Test Time Changing the Default Battery Test TimeInstalling Optional Navisphere 6.X Software Connecting the Service Laptop to the SP LAN PortInstalling Software Options MirrorViewUI SnapViewUI SANCopyUI AnalyzerUIStorage System Properties dialog box opens Setting Initial Security Parameters 10.42.12.1002162/setupUsing the Serial Cable Via the Serial Port Alternate Method 192.168.1.1/setupMaking Management and Switch or Host Connections LANConnecting a Fibre-Optic Switch or Fibre Channel Host Connecting the Fibre-optic Switch/Host Cables CX700 ShownConfiguring Your Host Server and Storage System Trademark Information