Lincoln Electric SP-135T manual Maintenance Safety Precautions, Routine Maintenance

Page 23

D-1

MAINTENANCE

D-1

 

 

 

MAINTENANCE

SAFETY PRECAUTIONS

WARNING

ELECTRIC SHOCK can kill.

•Disconnect input power by removing plug from receptacle before working inside SP-135T. Use only grounded receptacle. Do not touch electrically “hot” parts inside SP-135T.

•Have qualified personnel do the mainte- nance and trouble shooting work.

ROUTINE MAINTENANCE

POWER SOURCE COMPARTMENT

No user serviceable parts inside! Do not attempt to perform service in the power source (fixed) side of the SP-135T. Take the unit to an authorized Lincoln Service Center if you experi- ence problems. NO maintenance is required.

In extremely dusty locations, dirt may clog the air passages causing the welder to run hot with premature tripping of ther- mal protection. If so, blow dirt out of the welder with low pres- sure air at regular intervals to eliminate excessive dirt and dust build-up on internal parts.

WIRE FEED COMPARTMENT

1.When necessary, vacuum accumulated dirt from gearbox and wire feed section.

2.Occasionally inspect the incoming guide tube and clean inside diameter if necessary.

3.Motor and gearbox have lifetime lubrication and require no maintenance.

FAN MOTOR

Has lifetime lubrication — requires no maintenance.

WIRE REEL SPINDLE

Requires no maintenance. Do not lubricate shaft.

SP-135T

Page 22 Page 24
Image 23
Page 22 Page 24
Contents
SP-135T California Proposition 65 Warnings SafetyElectric Shock can kill Iii Welding Sparks can cause fire or explosionSûreté Pour Soudage a L’Arc Précautions DE SûretéOn-Line Product Registration Please Examine Carton and Equipment For Damage ImmediatelyMaster Table of Contents for ALL Sections Technical Specifications SP-135T InstallationElectric Shock can kill Safety PrecautionsIdentify and Locate Components Stacking Work Clamp InstallationSelect Suitable Location Output ConnectionsGAS Connection GUN InstallationWork Cable Installation Connecting Gun Cable to the SP-135TFigure A.5 Requirements For Rated Output Input ConnectionsCode Requirements for Input Connections Recommended Processes Design FeaturesOperation General DescriptionLimitations Controls and SettingsWelding Capability Sequence of Operation Wire LoadingWelding Operations Wire Threading Friction Brake AdjustmentMaking a Weld Cleaning Tip And NozzleProcess Guidelines Overload Protection Changing Machine Over to Feed Other Wire SizesWelding with Gmaw MIG Application Chart Innershield Fcaw Conversion AccessoriesOptional Accessories K586-1 Deluxe Adjustable Gas RegulatorReplacement Parts 2ACCESSORIESC-2Routine Maintenance MaintenanceMaintenance Safety Precautions Contact Tip Cable Liner Drive Roll GUN and Cable MaintenanceConfiguration of Components in Wire Feeding System For Magnum 100L GUNChanging Drive Roll Component Replacement ProceduresChanging the Contact TIP Liner trim length Changing LinerGUN Handle Parts HOW to USE Troubleshooting Guide TroubleshootingRecommended Course of Action Problems Possible Areas Symptoms MisadjustmentsFacility Authorized Field ServiceContact your local Lincoln Welding Problems Diagrams SP-135T SP-135T Precaucion Warnung
Related manuals
Manual 36 pages 30.59 Kb