TROUBLESHOOTING | ||
| Observe all Safety Guidelines detailed throughout this manual |
|
PROBLEMS | POSSIBLE | |
(SYMPTOMS) | CAUSE | |
|
| OUTPUT PROBLEMS |
Major physical or electrical damage | None | |
is evident. | Contact your local Authorized Field | |
| Service Facility. | |
|
|
|
No wire feed, weld output or gas | 1. | Make sure correct voltage is |
flow when gun trigger is pulled. Fan |
| applied to the machine. See |
does NOT operate. |
| Installation section, “Electrical |
|
| Connections”. |
| 2. | Make certain that power switch |
|
| is in the ON position. |
| 3. | Make sure circuit breaker is |
|
| reset. |
|
|
|
No wire feed, weld output or gas | 1. | The thermostat may be tripped |
flow when gun trigger is pulled Fan |
| due to overheating. Let machine |
operates normally. |
| cool. Weld at lower duty cycle. |
| 2. | Check for obstructions in air |
|
| flow. |
| 3. | Check Gun Trigger connections. |
|
| See Installation section. |
RECOMMENDED COURSE OF ACTION
Contact your local Lincoln Authorized Field Service Facility.
4. Gun trigger may be faulty.
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
LOCAL AUTHORIZED LINCOLN ELECTRIC FIELD SERVICE FACILITY for assistance before you proceed.