TROUBLESHOOTING | ||
|
|
|
| Observe all Safety Guidelines detailed throughout this manual |
|
|
|
|
PROBLEMS
(SYMPTOMS)
POSSIBLE
CAUSE
RECOMMENDED
COURSE OF ACTION
| Engine will not go to high idle when | 1. | Auxiliary power load is less than |
|
| ||
| using auxiliary power. |
| 100 watts. Idler may not respond |
|
| ||
|
|
| with less than a 100 watt load. Set |
|
| ||
|
|
| idler to "High". |
|
| ||
|
| 2. | Faulty PC board.(Control or Idler). |
|
| ||
|
|
|
|
|
|
|
|
| Engine will not go to high idle | 1. | Faulty idler solenoid. Check for |
|
| ||
| under weld or auxiliary loading. |
| bent linkage or broken spring. |
|
| ||
|
| 2. | Faulty PC board.(Control or Idler). |
|
| ||
|
|
|
|
|
|
|
|
| Engine does not develop full | 1. | Fuel filter clogged, Replace. |
|
| ||
| power. Engine runs rough. | 2. | Air filter clogged, clean or replace. |
|
| ||
|
| 3. | High idle setting incorrect, check |
|
| ||
|
|
| and adjust if required. |
|
| ||
|
| 4. | Valves out of adjustment. |
|
| ||
|
| 5. | Fuel contaminated with water or |
|
| ||
|
|
| sediment. Check fuel |
|
| ||
|
|
| and empty of water, bleed fuel |
|
| ||
|
|
| system. Replace fuel in tank if |
|
| ||
|
|
| needed. |
|
| ||
|
|
|
|
|
|
|
|
| Engine will not go to high idle when | 1. | Broken spring on Idle Solenoid, |
|
| ||
| attempting to weld or using auxil- |
| solenoid linkage binding, Faulty | If all recommended possible | areas | ||
| iary power. Switching to manual |
| PC board (Control or Idler), low | of misadjustment have | been | ||
| high idle does not work. |
| idle speed set too low on idle | checked and the problem persists, | |||
|
|
| solenoid. | Contact your local Lincoln | |||
|
|
|
|
|
| Authorized Field Service Facility. | |
| Engine will not shut off. | 1. | Fuel Shutdown solenoid not func- | ||||
|
|
| |||||
|
|
| tioning properly / linkage binding. |
|
| ||
|
|
| Stop engine by shutting off valve |
|
| ||
|
|
| located on main fuel filter. Contact |
|
| ||
|
|
| authorized local Engine Service |
|
| ||
|
|
| Shop. |
|
| ||
|
|
|
|
| |||
Engine does not develop full power. 1. Fuel filter dirty/clogged. Replace. |
|
| |||||
Low weld and auxiliary output. | 2. Air filter dirty/clogged. Replace Air |
| |||||
Engine runs rough. |
| Filter Element. |
|
| |||
|
| 3. Fouled fuel injector(s). Contact |
| ||||
|
|
| authorized Engine Service Shop. |
|
| ||
|
| 4. Fuel contaminated with water. |
| ||||
|
|
| Check water separator for water. |
| |||
|
|
| Clean and replace as needed. |
| |||
|
|
| Replace fuel in tank. |
|
| ||
|
| 5. Cracked or loose fuel hose. |
| ||||
|
|
| Replace hose and tighten clamps. |
|
| ||
|
| 6. Valves out of adjustment. Contact |
| ||||
|
|
| authorized local Engine Service |
| |||
|
|
| Shop. |
|
| ||
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.