Craftsman 919.724701 owner manual Assembly

ASSEMBLY

Contents of Carton

1 -	Air Compressor
1 -	Handle
1 -	Grip Handle
4 - Self Tapping Screw
2 -	Wheels
2 -	Shoulder Bolts, 3/8-16
2 -	Hex Nuts, 3/8-16
1 -	Rubber Strip

Tools Required for Assembly

1 - 9/16" socket or open end wrench

1 - 1/2" socket or open end wrench

Assemble Handle

1.To make installation easier, submerge handle grip into warm soapy water. Remove handle grip from soapy water and slide onto handle.

2.Insert the handle inside the compressor saddle and line up the two bolt holes on each side.

Handle

Grip

Screw

Handle

Nut

Shoulder

Wheel Bolt

Rubber Strip

3.Install the four screws, two on each side.

4.Tighten securely.

Assemble Wheels

It will be necessary to

brace or support one side of the unit when installing the wheels because the compressor will have a tendency to tip.

1.Attach wheels with shoulder bolts and nuts as shown. NOTE: Place the bolts in the bottom hole of the wheel bracket on units 20-29 gallons and in the top hole on units 30 gallons and up.

2.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.

The wheels and handle do not

provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.

Assemble Rubber Strip

1.Clean and dry underside of air tank leg opposite wheels.

2.Remove the protective paper strip from the adhesive backed rubber foot strip.

3.Attach the rubber foot strip to the bottom of leg. Press firmly into place.

D27610 10- ENG