12
Windows CE Driver
Printer Settings
Table 3 • Parameter Settings and Defaults
Parameter | Value Range | Default Value |
|
|
|
Media Tracking | Continuous, Variable Length, | Variable Length |
| Mark Sensing |
|
|
|
|
Top Margin (mm) | 2 mm to 10 mm | 10 mm |
|
|
|
Bottom Margin (mm) | 0 to 9 mm | 0 |
|
|
|
Cutter Mode | None, Every Page, End of | Every Page |
| Document |
|
|
|
|
Partial Cut Width | 0, 10 mm to 60 mm | 0 |
|
|
|
Presenter Loop Length | 0 to 600 mm | 416 mm |
|
|
|
Eject Length | 20 mm to 600 mm | 50 mm |
|
|
|
Present Length Addition | 0 to 255 mm | 0 |
|
|
|
Presenter Timeout | 0 to 300 seconds | 0 |
|
|
|
Clear Presenter | Disable, Enable | Disable |
|
|
|
Presenter Mode | Eject, Retract | Eject |
|
|
|
•OK – applies the settings and exits the program
•Cancel – does not apply the settings and exits the program
•Apply – applies the settings but does not exit the program
•Default – sets all settings to factory default
The following parameter settings are sent to the printer during each print job.
Media Width
The media width can be set to 58 mm, 60 mm, 80 mm and 82.5 mm. The default setting is 80 mm.
Media Height
The media height can be set between the minimum page length of 90 mm and the maximum page length of 600 mm. The default setting is 150 mm.
Darkness
The Darkness can be set between 1 and 15 with 1 being the lightest. The default setting is 9.
Max Print Speed
The max print speed can be set between 47 mm and 150 mm per second (mm/s). The default setting is 150 mm/s. The actual print speed may vary depending on the darkness and the content printed.
TTP 2030™ Windows CE Software Integrator Guide | 4/14/2013 |