Zebra Technologies TTP 2030 manual Tools Tab

Page 20

16

Windows CE Driver

Printer Settings

Tools

The Tools tab enables printer maintenance functions.

Figure 5 • Tools Tab

Printer Port setting – tells the driver to which port the printer is connected Clear Kiosk Presenter – ejects any media in the presenter

Send PRN File – sends a saved PRN file to the printer

Set Black Mark Mode – sets the printer to use black mark media Set Continuous Mode – sets the printer to print continuous pages Save Parameter – saves the Parameter Settings

Feed One Receipt – feeds a single blank receipt

Print Config Label – prints a page with the printer configuration information

P1055866-001

TTP 2030™ Windows CE Software Integrator Guide

4/14/2013

Image 20

Contents Zebra TTP Page Contents Troubleshooting Document Conventions Who Should Use This DocumentHow This Document Is Organized Introduction Description Windows CE DriverPrinter Driver Driver FunctionsStatus Monitoring Port MonitorPrint Spooling GetPrinterStatus TTP 2030 Status codesTypes of Status Monitoring NAK 0FPrinter and Driver Parameter Setting and Maintenance Control Panel ExtensionInstallation Firmware UpdateCE Driver Installation UI OptionCommand Line Option To create a shortcut filePrinter Settings Device SettingsMedia Width Media HeightDarkness Max Print SpeedCutter Mode Media TrackingTop Margin Bottom MarginPresenter Timeout Partial Cut WidthPresenter Loop Length Eject LengthPresenter Mode Clear PresenterTools Tools TabAbout About tab shows the current driver versionSetting Black Mark Mode To set black mark modeStatus Light Descriptions LED StatesTroubleshooting No print on the label Print Quality ProblemsStatus Indicator Printed image does not look right Media Sensing Problems Black Mark Calibration ProcessPrinter will not load the media Printer will not eject the mediaOther Problems Receipts are not cutting properlyThere are no lights on the printer Receipts are not cutting at the black markContact Technical Support