3
Troubleshooting
Status Light Descriptions
LED States
Immediately after power is applied to the printer, a brief self test is performed and the status light will report the following conditions:
Table 1 • LED States
Solid Green | 0 - OK | This code is reported when no other |
|
| codes are active. It indicates the |
|
| printer is functioning normally. |
|
|
|
One Red Flash | 1 - Paper Jam in | This code indicates that media is stuck |
| Presenter | in the presenter. This error is set when |
|
| the printer attempts to eject the media |
|
| but cannot complete the operation. |
|
| This error is cleared by removing the |
|
| media from the presenter sensor. |
|
|
|
Two Red Flashes | 2 - Cutter Jam | This code indicates that the printer |
|
| could not find the cutter blade or could |
|
| not properly manage its position. The |
|
| error is set when the printer attempts |
|
| to cut but fails after three retries. This |
|
| error is cleared by cycling the power |
|
| off and on. |
|
|
|
4/14/2013 | TTP 2030™ Windows CE Software Integrator Guide |