Zebra Technologies TTP 2030 manual Setting Black Mark Mode, To set black mark mode

Page 22

18

Windows CE Driver

Setting Black Mark Mode

Setting Black Mark Mode

The printer is optimized to detect black marks printed with IR sensitive ink and ignore preprint in IR blind ink as follows:

80 and 82.5 mm media – the black marks are centered 30 mm to the right of the paper center when viewing the imaged side of the receipt and print direction is downward

58 and 60 mm media – the black marks are centered 22 mm to the left of the paper when viewing the imaged side of the receipt and the print direction is downward

The printer supports media with black mark thickness in printing direction of 2.5-9.0 mm, and a width of 5.0-10.0 mm when the black mark is centered on the sensor.

Refer to the TTP 2000 Series Technical Manual (P1002902) available at www.zebra.com/support for black mark media requirements and media guide installation instructions.

To set black mark mode:

1.Choose the correct media guide for the desired media width.

2.Load the desired media.

3.In the Tools tab of the Windows driver, click Set Black Mark Mode. A dialog box appears asking you to confirm your selection.

4.Click Yes.

The printer feeds the media, detects the black marks, and ejects the media.

5.Press the Feed button on the printer several times to confirm the printer is cutting directly in the center of the black marks.

6.In the Device Settings tab of the Windows driver, set the Media Tracking to Mark Sensing.

Note • If you revert back to Continuous mode, set the Media Tracking back to Continuous or Variable.

P1055866-001

TTP 2030™ Windows CE Software Integrator Guide

4/14/2013

Image 22
Contents Zebra TTP Page Contents Troubleshooting How This Document Is Organized Who Should Use This DocumentDocument Conventions Introduction Description Windows CE DriverPrinter Driver Driver FunctionsPrint Spooling Port MonitorStatus Monitoring GetPrinterStatus TTP 2030 Status codesTypes of Status Monitoring NAK 0FPrinter and Driver Parameter Setting and Maintenance Control Panel ExtensionCE Driver Installation InstallationFirmware Update UI OptionCommand Line Option To create a shortcut filePrinter Settings Device SettingsDarkness Media WidthMedia Height Max Print SpeedTop Margin Cutter ModeMedia Tracking Bottom MarginPresenter Loop Length Presenter TimeoutPartial Cut Width Eject LengthPresenter Mode Clear PresenterTools Tools TabAbout About tab shows the current driver versionSetting Black Mark Mode To set black mark modeStatus Light Descriptions LED StatesTroubleshooting Status Indicator Print Quality ProblemsNo print on the label Printed image does not look right Media Sensing Problems Black Mark Calibration ProcessPrinter will not load the media Printer will not eject the mediaThere are no lights on the printer Other ProblemsReceipts are not cutting properly Receipts are not cutting at the black markContact Technical Support