![](/images/new-backgrounds/1258610/25861055x1.webp)
VARIABLE SPEED TRIGGER SWITCH
Never tape the trigger switch down to provide continuous high speed. The tool may fail under such conditions causing fire or personal injury.
The
TRIGGER
BUTTON
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Cordless Reciprocating Saw depends |
on the amount of pressure applied on |
the trigger. The further the trigger is pressed, |
the faster the tool will go. |
ATTACHING / REMOVING BLADE
Failure to remove the battery pack from the saw before removing the blade could result in accidental starting and serious personal injury.
BLADE CLAMP
•Remove the battery pack.
•Use the allen wrench to loosen the blade clamp screw on the side of the saw by turning it
• Press the |
Reciprocating Saw “ON”. To turn the Cordless Reciprocating Saw “OFF”, |
release the trigger switch. |
TO ATTACH BLADE:
•Press the hole in the shank of the blade onto the pin in the saw bar. Make sure that the teeth of the blade are facing downward.
•Tighten the blade clamp screw back into place.
•Remove allen wrench.
•Replace the battery pack.
TO REMOVE BLADE:
•Pull the hole in the shank of the blade off the pin in the saw bar.
•Tighten the blade clamp screw back into place.
•Remove allen wrench.
•Replace the battery pack.
13 | 14 |