OPERATING THE ON / OFF SWITCH Press the “ON/OFF” switch to turn the worklight “ON” and “OFF”.
ADJUSTING THE WORKLIGHT BEAM
Hold the handle of the Worklight securely in
one hand. With the other hand, swivel the 
UP head of the Worklight
until it is at the angle you desire. Swivel the head of the Worklight clockwise to return it to its original position.
1.Remove the battery pack from the Worklight.
2.Hold the top of the Worklight with one hand while twisting the rim in a
3.Remove the bulb by turning it slightly and pulling it out of the bulb fitting. Be careful not to damage the delicate parts inside the case.
4.Insert the new bulb, then carefully put the rim back in place and turn it clockwise to tighten it.
REPLACEMENT BULB
REPLACING THE LIGHT BULB
This Worklight uses a Krypton 18V, 0.6 A light bulb. Use of any other kind of light bulb may cause damage or injury.
Parts of this worklight heat up almost immediately when in use. To avoid burns, use caution when handling light bulb and metal reflector. Never change a hot light bulb. Bulb must be cool to the touch before attempting to remove or replace it.
For your convenience, a spare light bulb is included inside the unit. Unscrew the rim and carefully remove it from the light assembly.
MAINTENANCE AND CLEANING
Always remove the battery pack before attempting cleaning or maintenance.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the casing. Never immerse any part of the tool in a liquid. Always keep the ventilation openings clear.
Always clean the battery pack using only a dry cloth. Do not use liquids. Always unplug the charger before cleaning it.
Regularly clean the ventilation slots in your tool and charger using only a soft brush or dry cloth.
Never open the Worklight case, battery pack or charger. Do not attempt to repair the Worklight, battery pack or charger yourself. Opening any of these parts will void your warranty.
9 | 10 |