Studer Innotec XPC 1648 Maintenance, EC Compliance, Disabling some of the XP-COMPACT functions

STUDER INNOTEC XP-COMPACT

6.4.3.3 Second priority cut-off

The Auxiliary Contact can use to cut-off second priority load with the criteria of the battery status or overtemp. One of the 4 LED 15 to 18 or 10 will be chosen as the cut off criteria. The second prior- ity loads will be supply only if the battery as a sufficient residual capacity

6.5Disabling some of the XP-COMPACT functions

Each different function charger, inverter and transfer can be disabled. This is useful for specific applications witch required to disable some of these tree functions.

If you press the button (20) more than 2 seconds, you can have the access to the different possi- bilities shown in the following diagram.

In programming mode the display show only the different types of program with the three DEL 2,7 and 9 to each functions. To change the type of programming press shortly the button 20 until your reach to the right function use according table below. After 10 seconds the XP-COMPACT exits the programming mode and load the new change.

In user mode, the disabled functions are displayed by blinking LED. So you can see in witch mode is disabled.

6.5.1Diagram of the different mode

					Show an off LED
					Show a blinking LED
					Show a lighted LED
AC IN	1		8	AC OUT	All the functions are enabled. This is the fac-
		7			tory setting.
CHARGER	2		9	INVERTER
AC IN	1		8	AC OUT	The inverter is disabled. Only the transfer
		7			switch and the charger will work normally.
CHARGER	2		9	INVERTER
AC IN	1		8	AC OUT	Charger and transfer switch are disabled. the
		7			inverter will work continuously even if there is
CHARGER	2		9	INVERTER	a correct AC voltage at the input
AC IN	1		8	AC OUT	Inverter and charger are both disabled.
		7			Only the transfer switch function is enabled in
CHARGER	2		9	INVERTER	input voltage and frequency is OK.

7 Maintenance

Apart from the periodic controls mentioned for the connections, the XP-COMPACT does not need any maintenance. Keep the appliance clean and from time to time wipe it clean with a damp cloth.

8 EC Compliance

Hereby we state that the products described in this user manual meet the following standards:

EN50081 I/II, EN55014 – EN61000-2-3, IEC801 II/III/IV, LVD 73/23/EEC, EMC Dir. 89/336

CH-1950 Sion the 1st of January 2003 STUDER INNOTEC (R.Studer)

User manual XP-COMPACT V2.0 E 20