Studer Innotec HPC2512, HPC7048, HPC4024, HPC5048 user manual Installation Maintenance, EC Compliance

Page 24

STUDER INNOTEC

HP-COMPACT

AC IN

1

 

8

AC OUT

Charger and transfer switch are disabled. the

 

 

7

 

 

inverter will work continuously even if there is

CHARGER

2

9

INVERTER

a correct AC voltage at the input

 

 

 

 

 

 

AC IN

1

 

8

AC OUT

Inverter and charger are both disabled.

 

 

7

 

 

Only the transfer switch function is enabled

CHARGER

2

9

INVERTER

in input voltage and frequency is OK.

 

 

 

 

 

 

6 Installation Maintenance

Apart from the periodic controls mentioned for the connections, the HP-COMPACT does need any maintenance. Keep the appliance clean and from time to time, wipe it clean with a damp cloth.

7 EC Compliance

Hereby we state that the products described in this user manual comply with the following standards:

EN50081 I/II, EN55014 – EN61000-2-3, IEC801 II/III/IV, LVD 73/23/EEC, EMC Dir. 89/336

CH - 1950 Sion the 31th of January 2002

STUDER INNOTEC (R.Studer)

User manual

HP-COMPACT V3.0 E

24

Image 24
Contents User and installer Manual Summary Quality and Warranty Warranty DisclaimerGeneral Information Operating instructionsPrecautions Special precautionsIntroduction Battery charger Remote controlRemote control for Power Sharing Battery connectingMounting and installing Installation placeConnection in serie Connection in parallel and in serieGeneral instructions on connecting FixingConnections Protection cover of the terminals connectionsBattery CablingPre-installation settings Connection to batteryConnection to Remote control Connection to Temperature Sensor TempConnection to the 230Vac-consumer appliances AC Output Connection to the 230Vac Input AC InputControl Charger InverterDisplay and control parameters Push buttons Turning KnobsInverter Battery Condition Charge detection system „StandbyOverload Overheating Over TempCycle of charge Equalization chargingInput current repartition Power sharing Charging currentTransfer system Set the transfer voltage thresholdFast UPS- Mode for the Transfer Switch Delayed mode of the Transfer SystemMultifunctional Contact Remote Control Temperature sensorBattery voltage ProgrammingAuxiliary contact Table of voltage and timing thresholdSet the voltage and timing threshold PrincipleExample start of a genset with the HP-COMPACT Power cut of the second priority loads Diagram of the different modesManual operating of Auxiliary Contact Disabling some of the HP-COMPACT functionsInstallation Maintenance EC ComplianceTechnical Data HPC2512 HPC4024 HPC5048 HPC7048